Nissan Rogue (T33) 2021-Present Service Manual: On Board Diagnostic (obd) System

Diagnosis Description

This system is an on board diagnostic system that records exhaust emission-related diagnostic information and detects a sensors/actuator-related malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL) and stored in ECU memory as a DTC. The diagnostic information can be obtained with the diagnostic tool (GST: Generic Scan Tool).

GST (Generic Scan Tool)

When GST is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the Nissan Ariya vehicle and then enable various kinds of diagnostic tests. Refer to Description.

NOTE:

Service $0A is not applied for regions where it is not mandated.

    Operation
    Automatic Speed Control Device (ascd) Operation SWITCHES AND INDICATORS ASCD indicator CANCEL switch RES+ switch SET- switch MAIN switch     On the combination meter O...
    Diagnosis System (ecm)
    Diagnosis Description Driving Pattern CAUTION: Always drive at a safe speed. DRIVING PATTERN ADriving pattern A means a trip satisfying the following conditions. Engine speed re...

    Other materials:

    Intelligent Key Interlock Function (without Navigation System)
    System Description SYSTEM DIAGRAMINPUT SIGNAL AND OUTPUT SIGNAL Component Function BCM Recognizes the following status and transmits it to driver seat control unit via CAN communication: Ignition ON signal Door lock status signal (with Intelligent Key, front door request switch op ...

    Installation d'un dispositif de retenue pour enfant dos à la route à l'aide des ceintures de sécurité
    AVERTISSEMENT Pour votre Nissan Rogue, la ceinture de sécurité à trois points d'ancrage avec enrouleur à blocage automatique (ALR) doit impérativement être utilisée lors de l'installation d'un dispositif de retenue pour enfant. Ne pas utiliser le mode de blocage des enrouleurs (ALR) peut e ...

    Engine oil
    Checking engine oil level Park the vehicle on a level area and apply the parking brake. Warm up the engine to operating temperature. Shut the engine off and wait at least 10 minutes. Remove the dipstick, wipe it clean, then fully reinsert it. Remove the dipstick again and check the oil le ...