Nissan Rogue (T33) 2021-Present Service Manual: P04fa Egr Temperature

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P04fa Egr Temperature

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P04FA 00

EGR A control

(EGR "A" Control temperature Too High) 		Diagnosis condition —
Signal (terminal) —
Threshold ECM detects that a signal from EGR temperature sensor is 162 °C (324 °F) or more for 5 seconds under the condition that the EGR volume control valve is operating.
Diagnosis delay time —

POSSIBLE CAUSE

  • EGR cooler

  • EGR cooler cooling system

FAIL-SAFE

Fail safe mode Nissan Ariya Vehicle behavior
Device fix mode

  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.

  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC P04FA is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.

  • P0401

  • P0402

  • P044A

  • P044E

If applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC P0401: Refer to DTC Description.

  • DTC P0402: Refer to DTC Description.

  • DTC P044A: Refer to DTC Description.

  • DTC P044E: Refer to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING-1

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

>>

GO TO 3.

PRECONDITIONING-2

Is “Diagnosis Procedure” of DTC P04FA finished?

YES>>

GO TO 4.

NO>>

Proceed to DTC Diagnosis Procedure.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Drive the Nissan Ariya vehicle for 5 seconds or more under the conditions below.

    Intake air temperature 5°C (41°F) or more
    Engine coolant temperature 75°C (167°F) or more
    Nissan Ariya Vehicle speed 50 km/h (31 MPH)

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P04FA is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.

  • P0401

  • P0402

  • P044A

  • P044E

If applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC P0401: Refer to DTC Description.

  • DTC P0402: Refer to DTC Description.

  • DTC P044A: Refer to DTC Description.

  • DTC P044E: Refer to DTC Description.

NO>>

GO TO 2.

CHECK EGR COOLER COOLING SYSTEM

Check EGR cooler cooling system.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK EGR COOLER

Perform inspection as follows:

  • Check the inside of EGR cooler for clogging.

  • Check EGR cooler for damage and water leakage.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Repair or replace error-detected parts.

    P04f1 Evap System Purge Line
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P04F1 00 EVAP system purge line (EVAP System Purge Line Performa...
    P0500 Vss
    DTC Description DESCRIPTIONECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) ...

    Other materials:

    B24a4-11 Intake Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A4-11 INTAKE SENSOR (Intake sensor) Diagnosis condition Ignition switch ON Signal (Terminal) Intake sensor signal Threshold The intake sensor rec ...

    Dtc/circuit Diagnosis. Lin Communication Circuit
    Diagnosis Procedure CHECK BCM OUTPUT SIGNAL Ignition switch ON. Check signal between BCM harness connector and ground using an oscilloscope. (+) (−) Signal (Reference value) BCM Connector Terminal With type A meter: B123 91 Ground With type B meter: M18 ...

    Symptom Diagnosis. Wiper Deicer Does Not Operate
    Diagnosis Procedure CHECK WIPER DEICER RELAY Check wiper deicer relay. Refer to Component Inspection. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK WIPER DEICER Check wiper deicer. Refer to Component Function Check. I ...