Nissan Rogue (T33) 2021-Present Service Manual: P04f1 Evap System Purge Line
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P04F1 | 00 |
EVAP system purge line (EVAP System Purge Line Performance) |
Diagnosis condition | During fuel cut after engine warm-up |
| Signal (terminal) | Mass air flow sensor signal | |||
| Threshold | Signal voltage from mass air flow sensor signal is lower than threshold value. | |||
| Diagnosis delay time | 1 second | |||
POSSIBLE CAUSE
-
Disconnection of hose between PCV valve and air duct
-
EVAP purge line clogging
FAIL-SAFE
Engine Control System
ECM stops fuel vapor purging (EVAP canister purge volume control solenoid valve is closed)
Stop/Start System
Not applicable
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Ignition switch OFF and wait at least 10 seconds.
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 10 seconds.
TEST CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at ignition switch ON.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Warm up the engine to the normal operating temperature.
-
Drive the Nissan Ariya vehicle at 10 km/h (6 MPH) or more for at least 15 minutes.
-
Accelerate the vehicle to 60 km/h (38 MPH) and maintain the speed.
-
Release the accelerator pedal fully at least 5 seconds.
-
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK HOSE BETWEEN PCV VALVE AND AIR DUCT
Check hose between PCV valve and air duct connection.
Is the inspection result normal?
YES>>INSPECTION END
NO>>Repair or replace error-detected parts.
Other materials:
Removal and Installation. Lower Joint
Exploded View
Lower joint
Steering gear
Steering column assembly
: N·m (kg-m, ft-lb)
: Always replace after every disassembly.
Removal and Installation
REMOVALCAUTION:
Do not cause impact to steering column or shaft during removal or installation.
Do n ...
Driver Information & Multimedia. Warning Chime System
How to Use This Manual :: Application Notice
Information
Service information Design of combination meter
TYPE A
TYPE B
Precaution :: Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System ...
B24f4-12 Heated Steering Wheel Relay
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
B24F4-12
Heated steering wheel relay
(Heated steering wheel relay)
Diagnosis condition
Ignition switch ON
Signal (Terminal)
Heated steering wheel relay cont ...
