Nissan Rogue (T33) 2021-Present Service Manual: P0402 Egr System
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition | ||
| P0402 | 00 |
EGRC-BPT VALVE (EGR A flow excessive detected) |
Diagnosis condition | — |
| Signal (terminal) | — | |||
| Threshold | ECM detects that the difference between the differential pressure value (between before and behind the EGR volume control valve) calculated based on intake air amount and the estimated EGR sensor output value is equal to or more than the specified upper limit value for 6 seconds. | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
EGR differential pressure sensor hose clogging
-
EGR differential pressure sensor hose disconnection
-
EGR differential pressure sensor tube clogging
-
EGR differential pressure sensor tube disconnection
-
EGR cooler clogging
-
EGR guide tube clogging
-
EGR guide tube disconnection
FAIL-SAFE
| Fail safe mode | Nissan Ariya Vehicle behavior | |
|---|---|---|
| Device fix mode |
|
|
DTC CONFIRMATION PROCEDURE
CHECK DTC PRIORITY
If DTC P0402 is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.
-
P0101
-
P0103
-
P0407
-
P0408
-
P046E
-
P0486
If applicable DTC detected?
YES>>Perform diagnosis of applicable.
-
DTC P0101: Refer to DTC Description.
-
DTC P0103: Refer to DTC Description.
-
DTC P0407: Refer to DTC Description.
-
DTC P0408: Refer to DTC Description.
-
DTC P046E: Refer to DTC Description.
-
DTC P0486: Refer to DTC Description.
GO TO 2.
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
TEST CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.
>>
GO TO 3.
PERFORM DTC CONFIRMATION PROCEDURE
-
Drive the Nissan Ariya vehicle and accelerate from 50 km/h (32 MPH) to 80 km/h (50 MPH) within 15 seconds under the following conditions.
Intake air temperature 0°C (32°F) or more Engine coolant temperature 75°C (167°F) or more CAUTION:
Always drive at safe speed.
-
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK DTC PRIORITY
If DTC P0402 is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.
-
P0101
-
P0103
-
P0407
-
P0408
-
P046E
-
P0486
If applicable DTC detected?
YES>>Perform diagnosis of applicable.
-
DTC P0101: Refer to DTC Description.
-
DTC P0103: Refer to DTC Description.
-
DTC P0407: Refer to DTC Description.
-
DTC P0408: Refer to DTC Description.
-
DTC P046E: Refer to DTC Description.
-
DTC P0486: Refer to DTC Description.
GO TO 2.
CHECK EGR VOLUME CONTROL VALVE
Check the EGR volume control valve. Refer to Component Inspection.
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>Replace EGR volume control valve. Refer to ComponentPartsLocation.
Other materials:
Cvt: Ge0f14a. Symptom Diagnosis
Cvt Control System
Symptom Table
The diagnosis item number indicates the order of check. Start checking in the order from 1.
Perform diagnoses of symptom table 1 before symptom table 2.
Symptom Table 1 Diagnostic item Reference Symptom
Shift Shock Slips/Will Not Engage Other
...
System maintenance
To ensure proper operation of the driver monitoring system on the Nissan Rogue, keep the camera and surrounding area clean. Use a soft, damp cloth—such as one designed for lens cleaning—wrung out thoroughly, and gently wipe the surface to remove dust or dirt.
License information (ProPILOT Ass ...
P0106 Manifold Absolute Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0106
00
ABSL PRES SEN/CIRC
(Manifold Absolute Pressure/Barometric Pressure Sensor Circuit Range/Performance)
Diagnosis condition
—
Signal (terminal)
...
