Nissan Rogue (T33) 2021-Present Service Manual: P0401 Egr System

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0401 Egr System

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0401 00

EGR A FLOW INSUFFICIENT

(EGR A flow insufficient detected) 		Diagnosis condition —
Signal (terminal) —
Threshold ECM detects that the difference between the differential pressure value (between before and behind the EGR volume control valve) calculated based on intake air amount and the estimated EGR differential pressure sensor output value is equal to or less than the specified lower limit value for 6 seconds.
Diagnosis delay time —

POSSIBLE CAUSE

  • EGR differential pressure sensor hose clogging

  • EGR differential pressure sensor hose disconnection

  • EGR differential pressure sensor tube clogging

  • EGR differential pressure sensor tube disconnection

  • EGR cooler clogging

  • EGR guide tube clogging

  • EGR guide tube disconnection

FAIL-SAFE

Engine Control System

Fail safe mode Nissan Ariya Vehicle behavior
Device fix mode

  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.

  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.

Stop/Start System

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC P0401 is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.

  • P0101

  • P0103

  • P0407

  • P0408

  • P046E

  • P0486

If applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC P0101: Refer to DTC Description.

  • DTC P0103: Refer to DTC Description.

  • DTC P0407: Refer to DTC Description.

  • DTC P0408: Refer to DTC Description.

  • DTC P046E: Refer to DTC Description.

  • DTC P0486: Refer to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Drive the Nissan Ariya vehicle and accelerate from 50 km/h (32 MPH) to 80 km/h (50 MPH) within 15 seconds under the following conditions.

    Intake air temperature 0°C (32°F) or more
    Engine coolant temperature 75°C (167°F) or more

    CAUTION:

    Always drive at safe speed.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK DTC PRIORITY

If DTC P0401 is displayed with the following DTC, perform the trouble diagnosis for the applicable DTC.

  • P0101

  • P0103

  • P0407

  • P0408

  • P046E

  • P0486

If applicable DTC detected?

YES>>

Perform diagnosis of applicable.

  • DTC P0101: Refer to DTC Description.

  • DTC P0103: Refer to DTC Description.

  • DTC P0407: Refer to DTC Description.

  • DTC P0408: Refer to DTC Description.

  • DTC P046E: Refer to DTC Description.

  • DTC P0486: Refer to DTC Description.

NO>>

GO TO 2.

CHECK EGR VOLUME CONTROL VALVE

Check the EGR volume control valve. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace EGR volume control valve. Refer to ComponentPartsLocation.

    P0385 Ckp Sensor 2
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0385 00 CKP SENSOR B (Crankshaft Position Sensor "B" Circuit) D...
    P0404 Egr Volume Control Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0404 00 EGR A CONTROL (EGR A control circuit range/performance)...

    Other materials:

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...

    C1f00-1c Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F00 1C CONTROL UNIT (Control unit) Diagnosis condition When engine is running Signal (terminal) — Threshold ADAS control unit 2 internal malfunct ...

    Basic Inspection. System Setting
    Description The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driver seat control unit. For details, refer to Work Procedure.×: ApplicableSetting ...