Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: System Setting

Description

The settings of the automatic driving positioner system can be changed, using information display in the combination meter and the set switch. Always check the settings before and after replacing driver seat control unit. For details, refer to Work Procedure.

×: Applicable

Setting Change
Item Content Information display Set switch Factory setting
Entry/exit assist (seat)

Entry/exit assist (seat) can be selected:

ON (operated) – OFF (not operated)
x x ON

Work Procedure

CHOOSE METHOD

There are two ways of setting method.

Which method do you choose?

With information display>>

GO TO 2.

With set switch>>

GO TO 3.

WITH INFORMATION DISPLAY

  1. Ignition switch ON.

  2. Select "Exit Seat Slide" in "Driving Position" of “Nissan Ariya Vehicle settings” of "Settings" using information display to change between ON and OFF.

>>

GO TO 4.

WITH SET SWITCH

  1. Ignition switch OFF.

  2. Push setting button and hold for more than 10 seconds.

>>

GO TO 4.

CONFIRM THE OPERATION

Check the entry/exit assist function setting is changed.

Is the setting changed?

YES>>

Work End.

NO>>

Go To 1.

    Basic Inspection. Intelligent Key Interlock Storing
    Description Always perform the Intelligent Key interlock function storage when the driver seat control unit is replaced. The Intelligent Key interlock function will not operate ...
    Dtc/circuit Diagnosis. B2900-01 Sliding / Lifting Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2900-01 Sliding / lifting switch (Sliding / lifting switch)...

    Other materials:

    Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference FRONT SUSPENSION Noise Shake Vibration Shimmy Judder Poor quality ride or Improper installation, looseness ...

    Component Parts
    Brake Control System Component Parts Location A. Engine Room (LH Side) No. Component Function 1. Steering angle sensor Refer to Steering Angle Sensor. 2. Combination Meter Refer to Component Parts Location (Type A Meter) or Component Parts Location (Type B Meter) f ...

    Electric Shift Control Module
    Exploded View Electric shift control module         : N·m (kg-m, in-lb) : Vehicle front Removal and Installation REMOVALDisconnect the negative battery terminal. Refer to Exploded View. Remove instrument side panel LH. Refer to Exploded View. Disconnect the harn ...