Nissan Rogue (T33) 2021-Present Service Manual: P023c Charge Air Cooler Cooling Electric Water Pump

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P023C 00

Charged air cooler coolant pump

(Charge air cooler coolant pump control circuit high)
Diagnosis condition
  • Engine running at idle

  • Warm-up condition

  • Battery voltage: 11 – 16 V

Signal (terminal) Charge air cooler electric water pump signal
Threshold A signal duty of the charge air cooler electric water pump operation command sent from ECM is more than 98%
Diagnosis delay time 3 seconds or more

POSSIBLE CAUSE

  • Harness and connectors

    (Charge air cooler electric water pump command circuit is open or shorted.)

  • Charge air cooler electric water pump

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

NOTE:

When DTC Confirmation Procedure has been preciously conducted, always perform the following before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

NOTE:

Before performing this procedure, check that the battery voltage is more than 11 V during ignition switch ON.

  1. Start the engine and warm it up to the normal operating temperature.

  2. Wait at least 20 seconds.

  3. Check DTC.

Is DTC P023C detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

COMPONENT FUNCTION CHECK

With CONSULT

  1. Start the engine.

  2. On CONSULT screen, select “ENGINE”>>“Active Test”>>“Charge air cooler cooling electric water pump”.

  3. Check the value of charge air cooler electric water pump duty under the following conditions:

    Item Condition Value
    Electric water pump 1 duty Normal mode 20 – 80

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

GO TO 2.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP HARNESS CONNECTOR INSTALLATION

Check charge air cooler electric water pump harness connector installation condition visually and tectually.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP POWER SUPPLY-I

  1. Turn ignition switch OFF.

  2. Disconnect charge air cooler electric water pump harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between charge air cooler electric water pump harness connector and ground.

    + Voltage
    Charge air cooler electric water pump
    Connector Terminal
    E36 2 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 9.

NO>>

GO TO 4.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP POWER SUPPLY-II

  1. Turn ignition switch OFF.

  2. Disconnect electric water pump relay and electric purge pump relay harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between electric water pump relay and electric purge pump relay harness connector and ground.

    + Voltage
    Electric water pump relay and electric purge pump relay
    Connector Terminal
    F103 6 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 7.

NO>>

GO TO 6.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP POWER SUPPLY-III

  1. Turn ignition switch OFF.

  2. Check the voltage between electric water pump relay and electric purge pump relay harness connector and ground.

    + Voltage
    Electric water pump relay and electric purge pump relay
    Connector Terminal
    E103 7 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 7.

NO>>

GO TO 6.

CHECK FUSE

  1. Pull out 15A fuse (No. 98) from fuse.

  2. Check that 15A fuse is not blowing.

Is the fuse blown (open)?

YES>>

Replace the fuse after repairing the applicable circuit.

NO>>

Perform the trouble diagnosis for power supply circuit.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP POWER SUPPLY CIRCUIT

  1. Check the continuity between electric water pump relay and electric purge pump relay and charge air cooler electric water pump harness connector.

    Electric water pump relay and electric purge pump relay Charge air cooler electric water pump Continuity
    Connector Terminal Connector Terminal
    F103 6 E36 2 Existed
  2. Also check harness for short to power and short to ground.

Is the inspection result normal?

YES>>

GO TO 8.

NO>>

Repair or replace error-detected parts.

CHECK ELECTRIC WATER PUMP RELAY AND ELECTRIC PURGE PUMP RELAY

Check electric water pump relay and electric purge pump relay.Refer to Component Inspection.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace .

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP GROUND CIRCUIT

  1. Check the continuity between charge air cooler electric water pump harness connector and ground.

    Charge air cooler electric water pump Continuity
    Connector Terminal
    E36 4 Ground Existed
  2. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 10.

NO>>

Repair or replace error-detected parts.

CHECK CHARGE AIR COOLER ELECTRIC WATER PUMP CONTROL CIRCUIT

  1. Disconnect ECM harness connector.

  2. Check the continuity between ECM harness connector and charge air cooler electric water pump harness connector.

    ECM Charge air cooler electric water pump Continuity
    Connector Terminal Connector Terminal
    F72 39 E36 1 Existed
    32 3
  3. Also check harness for short to power and short to ground.

Is the inspection result normal?

YES>>

Replace charge air cooler electric water pump. Refer to Removal and Installation.

NO>>

Repair or replace error-detected parts.

    P023b Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P023B 00 Charged air cooler coolant pump (Charge air cooler cool...
    P025a Fuel Pump Relay
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P025A 00 FUEL PUMP MODULE A (Fuel Pump Module "A" Control Circui...

    Other materials:

    Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0028-09 SIDE A/B MODULE RH (Right Side Airbag Deployment Control) Diagnosis condition When ignition switch is ON. Signal (terminal) Front side air bag modu ...

    P02ee Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02EE 00 Cylinder 1 injector (Cylinder 1 Injector Circuit Range/Performance) Diagnosis condition Injector compensation control is operating Signal — ...

    Repair Information. Preparation
    Repairing Material Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Ariya vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...