Nissan Rogue (T33) 2021-Present Service Manual: P025a Fuel Pump Relay

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
P025A 00

FUEL PUMP MODULE A

(Fuel Pump Module "A" Control Circuit/Open)
Diagnosis condition The ignition switches on and the engine stops.
Signal (terminal) Fuel pump relay signal
Threshold When ECM detects open circuit depending on fuel pump relay operating voltage.
Diagnosis delay time ―

POSSIBLE CAUSE

  • Harness or connectors (circuit is open)

  • ECM internal malfunction

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

YES>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

Turn ignition switch ON and wait at least 15 seconds.

Is DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK FUEL PUMP

Check fuel pump. Refer to Component Inspection.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning part.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure. Refer to DTC Description.

Is the DTC P025A displayed again?

YES>>

Replace ECM. Refer to ECM : Removal & Installation.

NO>>

INSPECTION END

    P023a Charge Air Cooler Cooling Electric Water Pump
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P023A 00 Charged air cooler coolant pump (Charge Air Cooler Cool...
    P025b Fuel Pump Module a
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P025B 00 FUEL PUMP MODULE A (Fuel Pump Module "A" Control Circui...

    Other materials:

    Air Fuel Ratio Initial Learning
    Description Air fuel ratio initial learning of ECM to learn the air fuel ratio that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: When ECM is replaced* When engine assembly is replaced* When electric throttle con ...

    P0420 Three Way Catalyst Function
    DTC Description The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2.A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage capacity decreases, ...

    Automatic Emergency Braking. Ecu Diagnosis Information
    Adas Control Unit 2 List of ECU Reference ECU Reference ADAS control unit 2 (Without ProPILOT Assist 2.1) Reference Value Fail-safe (ADAS Control Unit 2) DTC Inspection Priority Chart DTC Index ADAS control unit 2 (With ProPILOT Assist 2.1) Reference Value Fail- ...