Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0028-09 Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0028-09 |
SIDE A/B MODULE RH (Right Side Airbag Deployment Control) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front side air bag module RH signal | ||
| Threshold | Front side air bag module RH circuit is shorted to other | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit of harness and connector
-
Internal malfunction of front side air bag module RH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT SIDE AIR BAG MODULE RH
-
Replace front side air bag module RH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
U2e52-87 Can Comm Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
U2E52
87
CAN communication error (ADAS control unit)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
CAN communication signal
Threshold
Not receiving from ADAS c ...
U012e Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U012E
00
Communication error (lost)
(Lost communication with camshaft position control module)
Diagnosis condition
Engine running at idle
Signal (terminal)
C ...
Dtc/circuit Diagnosis. Horn Function
Component Function Check
CHECK FUNCTION
CONSULT
Ignition switch OFF.
Perform “Horn” in “Active test” mode of “IPDM E/R”.
Check the horn operation.
Test item Description
Horn
On
Horn
Sounds (for 20 ms.)
Is the operation normal?
YES>>
Ins ...
