Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Horn Function

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Security Control System / Dtc/circuit Diagnosis :: Horn Function

Component Function Check

CHECK FUNCTION

CONSULT

  1. Ignition switch OFF.

  2. Perform “Horn” in “Active test” mode of “IPDM E/R”.

  3. Check the horn operation.

    Test item Description
    Horn On Horn Sounds (for 20 ms.)

Is the operation normal?

YES>>

Inspection End.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK HORN FUNCTION

Check horn function with horn switch.

Do horns sound?

YES>>

GO TO 2.

NO>>

Perform the trouble diagnosis for horn circuit. Refer to Wiring Diagram.

CHECK HORN RELAY CONTROL SIGNAL

CONSULT

  1. Ignition switch ON.

  2. Select "Horn" in "Active test" mode of "IPDM E/R".

  3. Check voltage between IPDM E/R harness connector and ground.

(+) (–) Test item

Voltage

(Approx.)
IPDM E/R
Connector Terminal
E119 9 Ground HORN On 0 V
Off Battery voltage

Is operation normal?

YES>>

GO TO 4.

NO>>

GO TO 3.

CHECK IPDM E/R POWER SUPPLY CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect horn relay connector and IPDM E/R connector.

  3. Check continuity between IPDM E/R harness connector and horn relay harness connector.

    IPDM E/R Horn relay Continuity
    Connector Terminal Connector Terminal
    E119 9 M98 3 Yes

  4. Check continuity between IPDM E/R harness connector and ground.

    IPDM E/R — Continuity
    Connector Terminal
    E119 9 Ground No

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.

    Dtc/circuit Diagnosis. Hood Switch
    Component Function Check CHECK FUNCTION CONSULT Select “Hood switch (CAN)” or “Hood switch” in “Data onitor” mode of “IPDM E/R”. Check “Hood switch (CAN)” or...
    Dtc/circuit Diagnosis. Starter Cut Relay
    Component Inspection CHECK STARTER CUT RELAY Ignition switch OFF. Disconnect starter cut relay. Check continuity between starter cut relay terminals. Starter cut relay Condition...

    Other materials:

    Nissanconnect. Preparation. Preparation
    Preparation Commercial Service Tools Tool Description Power tool Loosening screws Always Replace With New Parts Always Replace With New PartsNever Reuse These PartsPart CodeFor additional information: Washer - ROOF ANTENNA EXPLODED VIEW ...

    Steering Switch Signal B Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...

    Dtc/circuit Diagnosis. Drive Mode Select Switch Circuit
    Diagnosis Procedure CHECK DRIVE MODE SELECT SWITCH SIGNAL CIRCUIT Ignition switch OFF. Disconnect drive mode select switch harness connector and BCM harness connector. Check the continuity between drive mode select switch harness connector and BCM harness connector. 2WD models with ...