Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Starter Cut Relay

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Security Control System / Dtc/circuit Diagnosis :: Starter Cut Relay

Component Inspection

CHECK STARTER CUT RELAY

  1. Ignition switch OFF.

  2. Disconnect starter cut relay.

  3. Check continuity between starter cut relay terminals.

    Starter cut relay Condition Continuity
    Terminal
    6 7 12 V direct current supply between terminals 8 and 9 Yes
    No current supply No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace starter cut relay.

    Dtc/circuit Diagnosis. Horn Function
    Component Function Check CHECK FUNCTION CONSULT Ignition switch OFF. Perform “Horn” in “Active test” mode of “IPDM E/R”. Check the horn operation. Test item Descript...
    Dtc/circuit Diagnosis. Stop Lamp Switch
    Component Inspection CHECK STOP LAMP SWITCH Ignition switch OFF. Disconnect stop lamp switch connector. Check continuity between stop lamp switch terminals. Stop lamp switch Con...

    Other materials:

    Admission Valve
    Exploded View Air duct bracket Admission valve gasket Air duct hose Air duct     Comply with the installation procedure when tightening. Refer to Removal and Installation. To air duct. Refer to Exploded View. To turbocharger. Refer to Exploded V ...

    P1574 Ascd Vehicle Speed Sensor
    DTC Description DESCRIPTIONThe ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from VDC (Nissan Ariya vehicle dynamics control), and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to System Descri ...

    Action Test
    Ldw Work Procedure Perform action test to verify the customer's concern. Perform action test and check the system operation after system diagnosis. WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test. CAUTION: Fully understand the ...