Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Stop Lamp Switch

Nissan Rogue (T33) 2021-Present Service Manual / Body Exterior, Doors, Roof & Vehicle Security :: Security Control System / Dtc/circuit Diagnosis :: Stop Lamp Switch

Component Inspection

CHECK STOP LAMP SWITCH

  1. Ignition switch OFF.

  2. Disconnect stop lamp switch connector.

  3. Check continuity between stop lamp switch terminals.

    Stop lamp switch Condition Continuity
    Terminal
    1 2 Brake pedal Not depressed No
    Depressed Yes
    3 4 Not depressed Yes
    Depressed No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace stop lamp switch. Refer to Exploded View (without ProPILOT ASSIST), or Exploded View (with ProPILOT ASSIST).

    Dtc/circuit Diagnosis. Starter Cut Relay
    Component Inspection CHECK STARTER CUT RELAY Ignition switch OFF. Disconnect starter cut relay. Check continuity between starter cut relay terminals. Starter cut relay Condition...
    Symptom Diagnosis. Intelligent Key System Symptoms
    Diagnosis Procedure NOTE: Perform the self-diagnosis with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. SYMPTOM TABLE 1 (BOTH INTEL...

    Other materials:

    Dtc/circuit Diagnosis. B2c20-23 Starter Control Relay
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2C20-23 Starter control relay (Starter control relay) Diagnosis condition Ignition switch ON Signal (terminal) Starter cut relay signal Starter c ...

    Driver Assistance System. Removal and Installation
    Front Camera Unit Without Propilot Assist 2.1 Exploded View Front camera unit bracket Front camera unit Front camera cover Metal clip Pawl     Removal and Installation REMOVALCAUTION: Do not remove front camera unit bracket and front camera cover ...

    U2212 Can Comm Err (brake Unit)
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition U2212 87 CAN communication error brake unit Diagnosis condition Ignition switch ON Signal (terminal) CAN communication signal Threshold ECM is not recieving CAN communication ...