Nissan Rogue (T33) 2021-Present Service Manual: Malfunction Indicator Lamp (mil)

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Malfunction Indicator Lamp (mil)

Component Function Check

CHECK MIL FUNCTION

  1. Turn ignition switch ON.

  2. Check that MIL illuminates.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK DTC

Check that DTC UXXXX is not displayed.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Perform trouble diagnosis for DTC UXXXX. Refer to DTC Index.

CHECK COMBINATION METER FUNCTION

Perform self-diagnosis for combination meter. Refer to DTC Index (Full TFT meter) or DTC Index (7 inch information display).

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Perform the trouble diagnosis for the detected DTC.

CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to Intermittent Incident.

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation (Full TFT meter) or Removal and Installation (7 inch information display).

NO>>

Repair or replace malfunctioning part.

    Low Pressure Fuel Pump
    Component Function Check CHECK LOW PRESSURE FUEL PUMP FUNCTION Turn ignition switch ON. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel...
    Manifold Absolute Pressure (map) Sensor
    Component Inspection CHECK MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR Turn ignition switch OFF. Remove manifold absolute pressure (MAP) sensor with its harness connector. Install p...

    Other materials:

    B24a1-16 A/c Auto Amp. Power Supply
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A1-16 A/C AUTO AMP. POWER SUPPLY (Air conditioning automatic amplifier power supply) Diagnosis condition Ignition switch ON Signal (Terminal) Accessory p ...

    P34ae Electric Intake Valve Timing Control Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P34AE 00 A camshaft posi actuator posi sens B1 (A Camshaft Position Actuator Position Sensor A Circuit Low Bank 1) Diagnosis condition — Signal (termina ...

    Dtc/circuit Diagnosis. Drive Mode Select Switch Circuit
    Diagnosis Procedure CHECK DRIVE MODE SELECT SWITCH SIGNAL CIRCUIT Ignition switch OFF. Disconnect drive mode select switch harness connector and BCM harness connector. Check the continuity between drive mode select switch harness connector and BCM harness connector. 2WD models with ...