Nissan Rogue (T33) 2021-Present Service Manual: Magnetic Clutch

Nissan Rogue (T33) 2021-Present Service Manual / Ventilation, Heater & Air Conditioner :: Heater & Air Conditioning Control System / Manual Air Conditioning :: Dtc/circuit Diagnosis / Magnetic Clutch

Component Function Check

CHECK MAGNETIC CLUTCH OPERATION

CONSULT

  1. Select “HVAC TEST” in “Active test” mode of “HVAC”.

  2. Touch “MODE 1”.

  3. With operating the test item, check magnetic clutch operation by listening and viewing.

Does it operate normally?

YES>>

Inspection End.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK MAGNETIC CLUTCH

CONSULT

  1. Ignition switch ON.

  2. Select “HVAC TEST” in “Active test” mode of “HVAC”.

  3. With operating the test item, check voltage between IPDM E/R harness connector and ground.

    (+) (−) Condition Voltage
    IPDM E/R
    Connector Terminal
    F35 65 Ground Active test: HVAC TEST Off 0 V
    MODE 1 Battery voltage

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace IPDM E/R. Refer to Removal and Installation.

CHECK MAGNETIC CLUTCH POWER SUPPLY CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R connector and A/C compressor connector.

  3. Check continuity between IPDM E/R harness connector and A/C compressor harness connector.

    IPDM E/R A/C compressor Continuity
    Connector Terminal Connector Terminal
    F35 65 F27 1 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK MAGNETIC CLUTCH GROUND CIRCUIT FOR OPEN

Check continuity between A/C compressor harness connector and ground.

A/C compressor (–) Continuity
Connector Terminal
F27 2 Ground Yes

Is the inspection result normal?

YES>>

Replace A/C compressor. Refer to Removal and Installation.

NO>>

Repair harness or connector.

    Front Blower Motor
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fusible link are not blown (open). Unit Location Fuse No. Capacity Front blower motor Fuse block (J/...
    Ecv (electrical Control Valve)
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open). Unit Location Fuse No. Capacity A/C compressor IPDM E/R 71 10 A Is the fus...

    Other materials:

    A/f Sensor 1
    Component Function Check PERFORM COMPONENT FUNCTION CHECK With GST Start engine and warm it up to normal operating temperature. Drive the Nissan Ariya vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position. Shift the selector lever to the D position, ...

    Towing load/specification
    WARNING The towing capacities in this manual are general guidelines. Actual safe towing capacity of your Nissan Rogue depends on factory or dealer-installed equipment, passenger load, and cargo weight. You must weigh both the vehicle and trailer as described to determine true towing capacity. Never ...

    Preparation
    Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description  —  (NI-44372) Pull gauge Measuring steering wheel turning force and ball joint swinging force KV40107300 (NI-51751) Boot ban ...