Nissan Rogue (T33) 2021-Present Service Manual: Led Headlamp :: Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
Bulb Specifications
| Item | Type | Wattage (W) | |
|---|---|---|---|
| Headlamp | Headlamp (Hi) | LED | — |
| Headlamp (Lo) | LED | — | |
| Front combination lamp [front turn signal lamp (bulb type)] | Front turn signal lamp | 7444NA | 28/8W |
| Parking lamp/Daytime running light | LED | — | |
| Front side marker lamp | W5W | 5W | |
| Front combination lamp [front turn signal lamp (LED type)] | Parking lamp/Daytime running light/Front turn signal lamp | LED | — |
| Front side marker lamp | W5W | 5W | |
| Side turn signal lamp | Door mirror type | LED | — |
| Rear combination lamp (body side) | Stop lamp | LED | — |
| Tail lamp | LED | — | |
| Rear turn signal lamp | WY21W (amber) | 21W | |
| Rear side marker lamp | W5W | 5W | |
| Rear combination lamp (back door side) | Tail lamp | LED | — |
| Back-up lamp | W16W | 16W | |
| License plate lamp* | W5W | 5W | |
| High-mounted stop lamp | LED | — | |
*: Replacement of a single part is not possible because license plate lamp cannot disassemble. For replacement, replace license plate lamp as a set.
Other materials:
Precaution. Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and front passeng ...
Knock Sensor
Component Inspection
CHECK KNOCK SENSOR
Turn ignition switch OFF.
Disconnect knock sensor harness connector.
Check resistance between knock sensor terminals as follows.
NOTE:
It is necessary to use an ohmmeter which can measure more than 10 MΩ.
Knock sensor Condition Re ...
Removal and Installation. Inside Key Antenna
Japan Production Models
Removal and Installation
REMOVALRemove luggage rear plate. Refer to Removal and Installation.
Remove inside key antenna fixing clips , and then remove inside key antenna .
INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION:
N ...
