Nissan Rogue (T33) 2021-Present Service Manual: Knock Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Knock Sensor

Component Inspection

CHECK KNOCK SENSOR

  1. Turn ignition switch OFF.

  2. Disconnect knock sensor harness connector.

  3. Check resistance between knock sensor terminals as follows.

    NOTE:

    It is necessary to use an ohmmeter which can measure more than 10 MΩ.

Knock sensor Condition Resistance
Terminal
1 2 Temperature 20°C (68°F) 532 – 588 kΩ

CAUTION:

Never use any knock sensors that have been dropped or physically damaged. Use only new ones.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace malfunctioning knock sensor. Refer to Component Parts Location.

    Intake Camshaft Position Sensor
    Component Inspection CHECK INTAKE CAMSHAFT POSITION SENSOR -1 Turn ignition switch OFF. Loosen the fixing bolt of the sensor. Disconnect intake camshaft position sensor harness ...
    Low Pressure Fuel Pump
    Component Function Check CHECK LOW PRESSURE FUEL PUMP FUNCTION Turn ignition switch ON. Pinch fuel feed hose with two fingers. Fuel pressure pulsation should be felt on the fuel...

    Other materials:

    Removal and Installation. Steering Column
    Exploded View Steering column assembly Steering shaft lower cover Clip : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVALCAUTION: Do not cause impact to steering column or shaft during removal or installation. ...

    C1f89-97 Side Radar Rear Lh
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1F89 97 Side radar rear LH (Side radar rear left hand) Diagnosis condition When engine is running Signal (terminal) CAN communication signal Threshold ...

    Air Fuel Ratio Initial Learning
    Description Air fuel ratio initial learning of ECM to learn the air fuel ratio that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: When ECM is replaced* When engine assembly is replaced* When electric throttle con ...