Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide: Installing top tether strap

Nissan Rogue (T33) 2021-Present Owner’s Manual & User Guide / Safety - Seats, seat belts and supplemental restraint system / Child restraints / Installing top tether strap

WARNING

  • Child restraint anchorages are designed only for correctly installed restraints. Never attach adult seat belts or other equipment to these points—doing so may damage the anchors and compromise safety.
  • Avoid hooking the tether strap on the seatback carpet. Always use the designated tether anchor.

The top tether strap must be used when installing a forward-facing child restraint with seat belts in your Nissan Rogue.

First, secure the child restraint with the seat belt.

1. Remove the head restraint/headrest and store it safely. Reinstall it after removing the child restraint.

2. Route the top tether strap as shown.

3. Attach the tether strap to the tether anchor.

4. Refer to earlier installation steps before tightening the tether fully.

If you have questions about installing a tether strap, NISSAN recommends contacting a dealer.

    Forward-facing child restraint installation using the seat belts
    Basic information WARNING The three-point seat belt with ALR mode must be used when installing a child restraint. Not using ALR will result in an unsecured restraint, increasing...
    Booster seats
    Basic information For proper booster seat installation in your Nissan Rogue, follow these guidelines carefully. Precautions on booster seats WARNING If a booster seat or seat be...

    Other materials:

    Paddle Shifter
    Removal and Installation REMOVALFor servicing the Japan production paddle shifter, service the Japan production steering wheel. Refer to Removal and Installation.NOTE: The Japan production paddle shifter is serviced as an assembly with the Japan production ASCD steering switch (if so equip ...

    Exhaust Gas Temperature Sensor
    Component Inspection CHECK EXHAUST GAS TEMPERATURE SENSOR Turn ignition switch OFF. Disconnect exhaust gas temperature sensor harness connector. Check resistance between exhaust gas temperature sensor connector terminals. Exhaust gas temperature sensor Resistance (kΩ) Connecto ...

    Drive Plate
    Exploded View Drive plate Drive plate reinforcement Pilot converter O-ring (NMK production only) Crankshaft position sensor     Comply with the assembly procedure when installing. Refer to Removal and Installation. : Chamfered     : ...