Nissan Rogue (T33) 2021-Present Service Manual: Hvac Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
-
Turn the ignition switch OFF.
-
Disconnect the battery cable from the negative terminal.
-
Check the terminals and connectors of the A/C amp. for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair the terminal and connector.
CHECK HARNESS FOR OPEN CIRCUIT
-
Disconnect the connector of A/C amp.
-
Check the resistance between the A/C amp. harness connector terminals.
A/C amp. harness connector Resistance (Ω) Connector No. Terminal No. M55 50 70 Approx. 54 – 66
Is the measurement value within the specification?
YES>>GO TO 3.
NO>>Repair the A/C amp. branch line.
CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the A/C amp. Refer to the following.
-
Automatic air conditioning: Diagnosis Procedure
-
Manual air conditioning: Diagnosis Procedure
Is the inspection result normal?
YES (Present error)>>Replace the A/C amp. Refer to the following.
-
Automatic air conditioning: Removal and Installation
-
Manual air conditioning: Removal and Installation
Error was detected in the A/C amp. branch line.
NO>>Repair the power supply and the ground circuit.
Other materials:
Lower Anchors and Tethers for CHildren (LATCH) system
LATCH system anchor location
Basic information
Your Nissan Rogue includes special anchor points for LATCH-compatible child restraints. This system may also be called ISOFIX. With LATCH, you do not need to use the seat belt unless the combined weight of the child plus restraint exceeds 65 lbs ( ...
Intelligent Key battery replacement
WARNING
Do not ingest the battery — Chemical Burn Hazard. This product contains a coin/button cell battery. If swallowed, it can cause severe internal burns within hours and may lead to death.
Keep both new and used batteries away from children. If the battery compartment of your Nissan R ...
Adas Control Unit. Basic Inspection
Additional Service When Replacing Adas Control Unit 2
Without Propilot Assist 2.1
Work Procedure
Always perform the additional service after replacing the ADAS control unit 2.ADAS CONTROL UNIT 2 CONFIGURATION
Perform saving Nissan Ariya vehicle internal information according to "Replace ECU" i ...
