Nissan Rogue (T33) 2021-Present Service Manual: Hfm Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Hfm Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the Intelligent Key unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of Intelligent Key unit.

  2. Check the resistance between the Intelligent Key unit harness connector terminals.

    Intelligent Key unit harness connector Resistance (Ω)
    Connector No. Terminal No.
    M184 6 7 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the Intelligent Key unit branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the Intelligent Key unit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the Intelligent Key unit. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the Intelligent Key unit branch line.

NO>>

Repair the power supply and the ground circuit.

    Main Line Between Strg and Brake Circuit
    Diagnosis Procedure CHECK CONNECTOR Ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend a...
    Hvac Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the A/C amp. for...

    Other materials:

    Wireless Charger. System Description
    Component Parts Wireless Charger Component Parts Location A. Console finisher assembly No.Component 1. Wireless charger unit 2. Wireless charger indicator Wireless charger unit Wireless charger unit The wireless unit is located at the front of the center console. Wirel ...

    P00f2 Maf Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00F2 00 Humidity Sensor Circuit/Open (Humidity Sensor Circuit/Open) Diagnosis condition — Signal (terminal) Humidity sensor　signal Threshold ...

    P0441 Evap Control System
    DTC Description DTC DETECTION LOGICIn this evaporative emission (EVAP) control system, purge flow occurs during non-closed throttle conditions. Purge volume is related to air intake volume. Under normal purge conditions (non-closed throttle), the EVAP canister purge volume control solenoid ...