Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2920-09 Driver Seat Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: B2920-09 Driver Seat Control Unit

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2920-09

Driver seat control unit

(Driver seat control unit) 		Diagnosis condition The power consumption control of driver seat control unit is in wake-up state
Signal (terminal) —
Threshold Detects internal relay fixing
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

Driver seat control unit

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

REPLACE DRIVER SEAT CONTROL UNIT

Replace driver seat control unit. Refer to Removal and Installation.

>>

Inspection End.

    Dtc/circuit Diagnosis. B2906-11 Recliner Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2906-11 Recliner Sensor Diagnosis condition The Recliner Se...
    Dtc/circuit Diagnosis. B2920-55 Driver Seat Control Unit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2920-55 Driver seat control unit (Driver seat control unit) Dia...

    Other materials:

    Intelligent Around View Monitor system limitations
    Basic information WARNING Listed below are the system limitations for the Intelligent Around View Monitor. Failure to drive your Nissan Rogue in accordance with these limitations could result in serious injury or death. Do not use the Intelligent Around View Monitor with the outside mirrors in th ...

    Dtc/circuit Diagnosis. Passenger Door Mirror Control Module
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open): Unit Location Fuse No. Capacity Passenger door mirror control module Fuse block (J/B) 45 5 A   Is the fuse blown (open) ? YES>> Replace the bl ...

    Intelligent Around View Monitor. Preparation. Preparation
    Preparation Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description - (NI-53373) ADAS calibration laser level Target setup and ADAS calibration - (NI-53371) ADAS calibration rod ...