Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2920-55 Driver Seat Control Unit
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2920-55 |
Driver seat control unit (Driver seat control unit) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | — | |||
| Threshold | Configuration is incomplete | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Vehicle specifications for driver seat control unit is incomplete
FAIL-SAFE
Stop the automatic drive position function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Ignition switch OFF and wait at least 30 seconds.
-
Ignition switch ON and wait at least 30 seconds or more.
-
Select “Self diagnosis result� mode of “DRIVER SEAT�.
-
Check the DTC.
Is DTC “B2920-55� detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
PERFORM CONFIGURATION OF DRIVER SEAT CONTROL UNIT
Perform configuration of driver seat control unit. Refer to Description.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
-
Ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC “B2920–55� detected?
YES>>Replace driver seat control unit. Refer to Removal and Installation.
NO>>Inspection End.
Other materials:
Manual Air Conditioning. Precaution. Precautions
Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT
PRE-TENSIONER�, used along with a front seat belt, helps to reduce the
risk or severity of injury to the driver and ...
Removal and Installation. 12v Battery Current Sensor
Exploded View
: 12V battery current sensor
: Harness connector
: N·m (kg-m, in-lb)
Removal and Installation
REMOVALDisconnect the 12V battery current sensor connector .
Remove negative cable mounting nut , and then remove the negative cable .
Loosen 12V battery cu ...
Dtc/circuit Diagnosis. U2152-57 Can Comm Err (adas Control Unit)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
U2152-57
CAN comm err (ADAS control unit)
[Control area network communication error (ADAS control unit)]
Diagnosis condition
-
Signal (terminal)
-
Thre ...
