Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2906-11 Recliner Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: B2906-11 Recliner Sensor

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC detection condition
B2906-11 Recliner Sensor Diagnosis condition The Recliner Sensor signal is shorted to ground
Signal (terminal) Reclining Motor (terminal #5)
Threshold 0.00 - 0.352 V
Diagnosis delay time 100 mili- seconds or more

POSSIBLE CAUSE

  • LH reclining motor

  • Driver seat control unit

  • Wiring

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON and wait for 20 seconds or more.

  2. Check “Self diagnosis result” mode of “DRIVER SEAT”.

Is DTC detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK RECLINING MOTOR SENSOR SIGNAL

  1. Ignition switch OFF.

  2. Disconnect driver seat control unit and LH reclining motor.

  3. Check continuity between driver seat control unit harness connector and ground.

(+) (-) Continuity
Driver seat control unit
Connector Terminal
B213 36 Ground Yes

Is the inspection result normal?

YES>>

Connect driver seat control unit and LH reclining motor. Component Function Check

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. B2900-01 Sliding / Lifting Switch
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2900-01 Sliding / lifting switch (Sliding / lifting switch)...
    Dtc/circuit Diagnosis. B2920-09 Driver Seat Control Unit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detection condition B2920-09 Driver seat control unit (Driver seat control unit)...

    Other materials:

    Symptom Diagnosis. Anti-Pinch Function Does Not Operate
    Moonroof System Diagnosis Procedure PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to Description. Is the inspection result normal? YES>> Inspection End. NO>> Replace moonroof motor assembly. Refer to Removal and Installation. Sunshade Diagnosis Proce ...

    Basic information
    Precautions on child restraints WARNING Failure to follow the warnings and instructions for proper child restraint use and installation can lead to serious injury or death to a child or other passengers in a sudden stop or collision inside the Nissan Rogue: The child restraint must alw ...

    P2a01 Ho2s2
    DTC Description The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time.MALFUNCTION ATo judge the malfunctions of heated oxygen ...