Nissan Rogue (T33) 2021-Present Service Manual: A-Bag Branch Line Circuit

Diagnosis Procedure

WARNING:

  • Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.)

  • Never use unspecified tester or other measuring device.

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the air bag diagnosis sensor unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the main harness.

CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to Work Flow.

Is the inspection result normal?

YES>>

Replace the main harness.

NO>>

Replace parts whose air bag system has a malfunction.

    Hvac Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the A/C amp. for...
    Adp Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    For system malfunction
    Warning message/Warning light:     "MalfunctionSee Owner's Manual" Symptom: System malfunction Systems to check: TSR, RAB, RCTA, AEB with Pedestrian Detection, I-FCW, LDW, I-LI, BSW, I-BSI, ICC, Steering Assist, I-DA Remedy: Stop safely and restart the engine. If warnings persist ...

    P0191 Frp Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0191 00 FRP SENSOR A (Fuel Rail Pressure Sensor Circuit Range/Performance Bank 1) Diagnosis condition Ignition switch ON Signal (terminal) Fuel rail pressur ...

    Symptom Diagnosis. Front Wiper Does Not Operate
    Description The front wiper does not operate under any operation conditions. Diagnosis Procedure CHECK FRONT WIPER REQUEST SIGNAL INPUT CONSULT Select “ALL SIGNALS” in "Data monitor" mode of “IPDM E/R”. Switch the front wiper switch to HI and LO. With operating the front w ...