Nissan Rogue Service Manual: How to read wiring diagrams

How to follow trouble diagnoses

Description NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing.  Before performing trouble ...

Connector Symbols

Most of connector symbols in wiring diagrams are shown from the terminal side.  Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction ...

Other materials:

Periodic maintenance
REAR WHEEL HUB AND HOUSING Inspection INSPECTION Make sure the conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. WHEEL HUB AND BEARING INSPECTION  Move wheel hub and bearing in the axial direction by hand. Make sure there is no ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of the electric throttle control actuator or ECM is ...

P1574 ASCD vehicle speed sensor
Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...