Nissan Rogue (T33) 2021-Present Service Manual: Engine Oil Pressure Control Solenoid Valve

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / Engine Oil Pressure Control Solenoid Valve

Component Inspection

CHECK ENGINE OIL PRESSURE CONTROL SOLENOID VALVE-1

  1. Turn ignition switch OFF.

  2. Disconnect engine oil pressure control solenoid valve harness connector.

  3. Check resistance between engine oil pressure control solenoid valve terminals as follows.

    Engine oil pressure control solenoid valve Condition Resistance
    + −
    Terminal
    1 2 Temperature 20°C (68°F) 19.8 - 24.2 Ω
    1 Ground

    ∞Ω

    (Continuity should not exist)
    2

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace engine oil pressure control solenoid valve. Refer to Exploded View.

CHECK ENGINE OIL PRESSURE CONTROL SOLENOID VALVE-2

  1. Remove engine oil pressure control solenoid valve. Refer to Exploded View.

  2. Provide 12 V DC between engine oil pressure control solenoid valve terminals 1 and 2, and then interrupt it. Make sure that the plunger moves as shown in the figure.

    CAUTION:

    Do not apply 12 V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in engine oil pressure control solenoid valve.

    NOTE:

    Always replace O-ring when engine oil pressure control solenoid valve is removed.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace engine oil pressure control solenoid valve. Refer to Exploded View.

    Engine Coolant Temperature Sensor 2
    Component Inspection CHECK ENGINE COOLANT TEMPERATURE SENSOR 2 Turn ignition switch OFF. Disconnect engine coolant temperature sensor 2 harness connector. Remove engine coolant ...
    Engine Oil Pressure Sensor
    Component Inspection CHECK EOP SENSOR Turn ignition switch OFF. Disconnect EOP sensor harness connector. Check resistance between EOP sensor connector terminals. EOP sensor Resi...

    Other materials:

    System Description. Component Parts. Heated Steering Wheel System
    Heated Steering Wheel System Component Parts Location A. Center of instrument panel (view with A/C switch assembly and center vent finisher removed) No.ComponentFunction 1. Heated steering wheel Refer to Heated Steering Wheel. 2. A/C switch assembly (heated steering wheel switch) Ref ...

    B3a70 Intelligent Battery Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition B3A70 00 IBS Battery Temp Sensor Failure (Open Circuit) [IBS battery temp sensor failure (Open circuit)] Diagnosis condition Ignition switch ON Batte ...

    Diagnosis System [abs Actuator and Electric Unit (control Unit)]
    CONSULT Function APPLICATION ITEMSCONSULT can display each diagnostic item using the diagnostic test modes as follows. Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode Self Diagnosis Result Display Display Display Display non-network DTC which ABS ...