Nissan Rogue (T33) 2021-Present Service Manual: Engine Coolant Temperature Sensor 2

Component Inspection

CHECK ENGINE COOLANT TEMPERATURE SENSOR 2

  1. Turn ignition switch OFF.

  2. Disconnect engine coolant temperature sensor 2 harness connector.

  3. Remove engine coolant temperature sensor 2. Refer to Exploded View.

  4. Check the resistance between engine coolant temperature sensor 2 terminals by heating with hot water as shown in the figure.

    Engine coolant temperature sensor 2 Condition Resistance
    Terminal
    1 2 Temperature [°C (°F)] 20 (68) 2.37 – 2.63 kΩ
    50 (122) 0.68 – 1.00 kΩ
    90 (194) 0.236 – 0.260 kΩ

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace engine coolant temperature sensor 2. Refer to Exploded View.

    Engine Coolant Temperature Sensor 1
    Component Inspection CHECK ENGINE COOLANT TEMPERATURE SENSOR 1 Turn ignition switch OFF. Disconnect engine coolant temperature sensor 1 harness connector. Remove engine coolant ...
    Engine Oil Pressure Control Solenoid Valve
    Component Inspection CHECK ENGINE OIL PRESSURE CONTROL SOLENOID VALVE-1 Turn ignition switch OFF. Disconnect engine oil pressure control solenoid valve harness connector. Check ...

    Other materials:

    Fuel Injector Relay
    Component Inspection CHECK FUEL INJECTOR RELAY Turn ignition switch OFF. Remove fuel injector relay. Refer to Component Parts Location. Check the continuity between fuel injector relay terminals as per the following conditions. Fuel injector relay Condition Continuity + − ...

    System Description. Component Parts. Heated Steering Wheel System
    Heated Steering Wheel System Component Parts Location A. Center of instrument panel (view with A/C switch assembly and center vent finisher removed) No.ComponentFunction 1. Heated steering wheel Refer to Heated Steering Wheel. 2. A/C switch assembly (heated steering wheel switch) Ref ...

    Vehicle information display warnings and indicators
    Engine start operation indicator This indicator appears when the shift position is set to P (Park). It informs the driver that the engine will start when the ignition switch is pushed while depressing the brake pedal. The Nissan Rogue engine can be started directly in any ignition switch position. ...