Nissan Rogue (T33) 2021-Present Service Manual: Egr Volume Control Valve

Component Inspection

CHECK EGR VOLUME CONTROL VALVE-1

With CONSULT

  1. Ignition switch ON (engine stopped).

  2. Perform “EGR CONTROL VALVE” in “ACTIVE TEST” mode of “ENGINE” using CONSULT.

  3. Operate “Up” or “Down”, set “EGR VALVE POSITION” to 0 deg, and check value “V1” of “EGR VALVE POSITION SEN”.

Does “V1” become 0.5 ± 0.1 V?

YES>>

GO TO 2.

NO>>

Replace EGR volume control valve. Refer to Removal and Installation.

CHECK EGR VOLUME CONTROL VALVE-2

With CONSULT

Operate “Up” or “Down”, set “EGR VALVE POSITION” to 70 deg, and check value “V2” of “EGR VALVE POSITION SEN”.

Does “V1” become 3.6 ± 0.25 V?

YES>>

GO TO 3.

NO>>

Replace EGR volume control valve. Refer to Removal and Installation.

CHECK EGR VOLUME CONTROL VALVE-3

  1. Ignition switch OFF

  2. Remove EGR volume control valve. Refer to Removal and Installation.

  3. Check the resistance between EGR volume control valve terminals.

    EGR volume control valve

    Resistance

    (Approx.)
    Terminal
    6 5 1 - 100 Ω

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace EGR volume control valve. Refer to Removal and Installation.

CHECK EGR VOLUME CONTROL VALVE VISUALLY

Check if any foreign objects interferes with EGR volume control valve.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Repair or replace error-detected parts.

    Crankshaft Position Sensor
    Component Inspection CHECK CRANKSHAFT POSITION SENSOR (POS)-1 Turn ignition switch OFF. Loosen the fixing bolt of the sensor. Disconnect crankshaft position sensor (POS) harness...
    Egr Differential Pressure Sensor
    Component Inspection CHECK EGR DIFFERENTIAL PRESSURE SENSOR Turn ignition switch OFF. Remove EGR differential pressure sensor hose (intake and exhaust). Install pressure pump to...

    Other materials:

    Automatic Air Conditioning. Preparation. Preparation
    Preparation Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name   Description  — (NI-46534) Trim Tool Set Removing trim components Commercial Service Tools Tool name Description Power ...

    P00d2 Ho2s2 Heater
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00D2 00 Heated O2 sensor heater B1 sensor 2 (HO2S heater control circuit range/performance bank 1 sensor 2) Diagnosis condition — Signal (terminal) ...

    Removal and Installation. Parting Seal
    Exploded view Body side outer panel Front parting seal Rear parting seal Double-sided tape [t: 0.8 mm (0.031 in)]         :Clip :Nissan Ariya Vehicle front : Always replace after every disassembly. Removal and Installation ...