Nissan Rogue (T33) 2021-Present Service Manual: Egr Differential Pressure Sensor
Component Inspection
CHECK EGR DIFFERENTIAL PRESSURE SENSOR
-
Turn ignition switch OFF.
-
Remove EGR differential pressure sensor hose (intake and exhaust).
-
Install pressure pump to EGR differential pressure sensor port (intake side).
-
Turn ignition switch ON and check output voltage between ECM connector terminals as follows.
EGR differential pressure sensor Condition Voltage + − Terminal 2 3 Applied pressure kPa (kg/cm2, PSI) Not applied 1.0 V 100 (1.02, 14.5) 4.5 V
CAUTION:
Never apply pressure over 150kPa (1.53 kg/cm2, 21.75 PSI)
Is inspection result normal?
YES>>INSPECTION END
NO>>Replace EGR differential pressure sensor. Refer to Exploded View.
Other materials:
U2140-87 Can Comm Err (ecm)
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial
communication line for real time applications. It is an on-Nissan Ariya
vehicle multiplex communication line with high data communication speed
and excellent error detection ability. Modern Nissan Ariya vehicle is
equipped ...
Kr15ddt. System Description. System
System
Warning/indicator (on Information Display)
Low fuel warning
DESIGN/PURPOSEThis warns the driver that the fuel level is low.OPERATION AT COMBINATION METER CAN COMMUNICATION CUT-OFF OR UNUSUAL SIGNALFor
the operation for CAN communications blackout or abnormal signal
reception, refer t ...
Front Drive Shaft Boot (kr15ddt)
Exploded View
LEFT SIDE
Circular clip
Dust shield
Housing
Snap ring
Spider assembly
Stopper ring
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Dust shield
: Wheel s ...
