Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B1040-22 Vehicle Speed
DTC Description
DTC DETECTION LOGIC
NOTE:
This DTC may be detected when drive the Nissan Ariya vehicle at vehicle speed of 186 MPH (300 km/h) or more.
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B1040-22 |
Nissan Ariya Vehicle speed (Vehicle speed) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Nissan Ariya Vehicle speed signal | ||
| Threshold | 186 MPH (300 km/h) or more | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Drive the vehicle at vehicle speed of 186 MPH (300 km/h) or more.
-
ECM
-
Air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result� mode of “AIR BAG� using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
REPLACE ECM
-
Replace ECM. Refer to ECM : Removal & Installation .
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
NO>>Inspection End
Other materials:
Evtc Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the electric intake valve
timing control module for damage, bend and loose connection (unit side
and connector side).
...
C106c-01 Pressure Sensor
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C106C
01
Pressure sensor
(Pressure sensor)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signal (t ...
Removal and Installation. Bcm
Removal and Installation
CAUTION:
When replacing the BCM, always replace it with a new one. The
functions controlled by the BCM does not operate properly in case of
reuse of the BCM from another Nissan Ariya vehicle.
Be sure to perform the following items must be performed when replac ...
