Nissan Rogue (T33) 2021-Present Service Manual: Evtc Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Evtc Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the terminals and connectors of the electric intake valve timing control module for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Disconnect the connector of electric intake valve timing control module.

  2. Check the resistance between the electric intake valve timing control module harness connector terminals.

    Electric intake valve timing control module harness connector Resistance (Ω)
    Connector No. Terminal No.
    F113 3 1 Approx. 108 – 132

Is the measurement value within the specification?

YES>>

GO TO 3.

NO>>

Repair the electric intake valve timing control module branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the electric intake valve timing control module. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the electric intake valve timing control module. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the electric intake valve timing control module branch line.

NO>>

Repair the power supply and the ground circuit.

    Tcm Branch Line Circuit (drivetrain Can Communication 1 Circuit)
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the TCM for dama...
    A-Amp. Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    Egr Temperature Sensor
    Component Inspection CHECK EGR TEMPERATURE SENSOR Turn ignition switch OFF. Disconnect EGR temperature sensor harness connector. Remove EGR temperature sensor. Check resistance between EGR temperature sensor terminals. EGR temperature sensor Condition Resistance  + − ...

    P2123 App Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2123 00 APP SEN 1/CIRC (Throttle/Pedal position sensor/switch D circuit high) Diagnosis condition Engine running at idle Signal (terminal) Accelerator ...

    Preparation
    Commercial Service Tools Tool Description Power tool Loosening screws Sealant or/and Lubricant Name Description Primer (3M K500, K520 or equivalent) Primer for attaching sonar sensor holder to bumper ...