Nissan Rogue (T33) 2021-Present Service Manual: A-Amp. Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / A-Amp. Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

    • BOSE speaker amp.

    • 8CH CAN gateway

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Disconnect the connector of 8CH CAN gateway.

  2. Check the continuity between the 8CH CAN gateway harness connector terminals.

    8CH CAN gateway harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    M45 25 M9 55 Existed
    26 56 Existed

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Check the harness and repair the root cause (IT CAN communication 1 circuit side). Refer to Diagnosis Procedure.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Connect the connector of 8CH CAN gateway.

  2. Disconnect the connector of BOSE speaker amp.

  3. Check the resistance between the BOSE speaker amp. harness connector terminals.

    BOSE speaker amp. harness connector Resistance (Ω)
    Connector No. Terminal No.
    B39 28 27 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 4.

NO>>

Repair the BOSE speaker amp. branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the BOSE speaker amp. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES (Present error)>>

Replace the BOSE speaker amp. Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the BOSE speaker amp. branch line.

NO>>

Repair the power supply and the ground circuit.

    Evtc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the electric int...
    Anc Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    For Side and Rollover Collision
    When SRS is activated in a collision FOR SIDE AND ROLLOVER COLLISION: When SRS is activated in a collisionCAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all Nissan Ariya vehicles. WORK PROCEDURE Before performing any of the following steps, e ...

    Removal and Installation. Inside Key Antenna
    Japan Production Models Removal and Installation REMOVALRemove luggage rear plate. Refer to Removal and Installation. Remove inside key antenna fixing clips , and then remove inside key antenna . INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION: N ...

    Precautions on seat belt usage
    Wearing your seat belt correctly — sitting upright, positioned well back in the seat, and keeping both feet on the floor — significantly reduces the risk of injury or death in an accident. When used properly, seat belts work together with your Nissan Rogue’s safety systems, including suppleme ...