Nissan Rogue (T33) 2021-Present Service Manual: Egr Temperature Sensor

Component Inspection

CHECK EGR TEMPERATURE SENSOR

  1. Turn ignition switch OFF.

  2. Disconnect EGR temperature sensor harness connector.

  3. Remove EGR temperature sensor.

  4. Check resistance between EGR temperature sensor terminals.

    EGR temperature sensor Condition Resistance 
    +
    Terminals
    1 2 Temperature 0°C (32°F) 624 –1053 kΩ
    50°C (122°F) 64.6 –93.5 kΩ
    100°C (212°F) 11.4 –15.1 kΩ

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace EGR temperature sensor. Refer to Exploded View.

    Egr Differential Pressure Sensor
    Component Inspection CHECK EGR DIFFERENTIAL PRESSURE SENSOR Turn ignition switch OFF. Remove EGR differential pressure sensor hose (intake and exhaust). Install pressure pump to...
    Electric Wastegate Control Actuator
    Component Inspection INSPECTION START Do you have CONSULT? Do you have CONSULT? YES>> GO TO 2. NO>> GO TO 3. CHECK ELECTRIC WASTEGATE CONTROL ACTUATOR With CONSULT T...

    Other materials:

    P0607 Ecm
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0607 00 ECM (Control module performance) Diagnosis condition Ignition switch ON Signal (terminal) — Threshold ECM internal communication sys ...

    2wd. Symptom Diagnosis. Noise, Vibration and Harshness (nvh) Troubleshooting
    Noise, Vibration and Harshness (nvh) Troubleshooting NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. Possible cause and SUSPECTED PARTS Symptom Reference REAR AXLE Noise Shake Vibration Shimmy Judder Poor quality ...

    Removal and Installation. Fillet Molding
    Exploded View 1. Front fillet molding 2. Rear fillet molding front 3. Rear fillet molding rear 4. Grommet — — — — : Clip : Pawl : Nissan Ariya Vehicle front Front Fillet Molding Removal and Installation REMOVALRemove front fille ...