Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Washer Fluid Level Switch Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Wiper & Washer / Dtc/circuit Diagnosis :: Washer Fluid Level Switch Circuit

Diagnosis Procedure

CHECK WASHER FLUID LEVEL SWITCH CIRCUIT

  1. Disconnect combination meter and washer fluid level switch connector.

  2. Check continuity between combination meter harness connector and washer fluid level switch harness connector.

    Combination meter Washer fluid level switch Continuity
    Type Connector Terminal Connector Terminal
    A M73 15 E82 2 Yes
    B M76

  3. Check continuity between washer fluid level switch harness connector and ground.

    Washer fluid level switch (—) Continuity
    Connector Terminal
    E82 2 Ground No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness.

CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT

Check continuity between washer fluid level switch harness connector and ground.

Washer fluid level switch (—) Continuity
Connector Terminal
E82 1 Ground Yes

Is the inspection result normal?

YES>>

Replace washer fluid level switch. Refer to Removal and Installation.

NO>>

Repair or replace harness.

    Dtc/circuit Diagnosis. Rain and Light Sensor
    Component Function Check CHECK FRONT WIPER AUTO OPERATION Clean the rain and light sensor detection area of windshield fully. When the front wiper switch is turned to AUTO posit...
    Symptom Diagnosis. Wiper and Washer System Symptoms
    Symptom Table (Without Rain and Light Sensor) NOTE: Perform the "Self diagnosis result" with CONSULT before the symptom diagnosis. Perform the trouble diagnosis if any DTC is de...

    Other materials:

    Dtc/circuit Diagnosis. Door Lock Actuator
    Front Lh Diagnosis Procedure CHECK DOOR LOCK ACTUATOR INPUT SIGNAL Ignition switch OFF. Disconnect front door lock assembly LH connector. Check voltage between front door lock assembly LH harness connector and ground. (+) (–) Condition Voltage (Approx.) Front door lock a ...

    Automatic Brake Hold. Removal and Installation
    Chassis Control Module Removal and Installation Removal and installation procedure of chassis control module. Refer to Removal and Installation. Automatic Brake Hold Switch Removal and Installation Removal and installation procedure of parking brake switch. Refer to Removal and Installation.NOTE: ...

    Diagnosis System (tcm)
    Diagnosis Description 1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis NOTE: “Start the engine and turn OFF the ignition switch after warm-up.” This is defined as 1 trip. 1 TRIP DETECTION DIAGNOSISWhen initial malfunction is detected, TCM memorizes DTC. In these diagnoses, some ...