Nissan Rogue (T33) 2021-Present Service Manual: Automatic Brake Hold :: Removal and Installation
Chassis Control Module
Removal and Installation
Removal and installation procedure of chassis control module. Refer to Removal and Installation.
Automatic Brake Hold Switch
Removal and Installation
Removal and installation procedure of parking brake switch. Refer to Removal and Installation.
NOTE:
Automatic brake hold switch and parking brake switch are a single unit.
Other materials:
P11b0 Vcr Target Angle (cold Start)
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P11B0
00
VCR target angle (cold start)
[Variable compression ratio target angle (cold start)]
Diagnosis condition
Engine cold start
Signal (terminal)
...
Automatic Drive Positioner
System Description
SYSTEM DIAGRAMSeveral types of signals are transmitted from the following units to the driver seat control unit via CAN communication.INPUT SIGNAL AND OUTPUT SIGNAL Component Signal
ABS actuator and electric unit (control unit)
Nissan Ariya Vehicle speed signal
Combin ...
Engine oil
Checking engine oil level
Park the vehicle on a level area and apply the parking brake.
Warm up the engine to operating temperature.
Shut the engine off and wait at least 10 minutes.
Remove the dipstick, wipe it clean, then fully reinsert it.
Remove the dipstick again and check the oil le ...