Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Rain and Light Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Driver Controls :: Wiper & Washer / Dtc/circuit Diagnosis :: Rain and Light Sensor

Component Function Check

CHECK FRONT WIPER AUTO OPERATION

  1. Clean the rain and light sensor detection area of windshield fully.

  2. When the front wiper switch is turned to AUTO position, front wiper operates once regardless of a rainy condition.

Is front wiper (AUTO) operation normal?

YES>>

Rain and light sensor is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK FUSE

Location Fuse No. Capacity
Fuse block (J/B) 31 15 A

Is the fuse blown (open)?

YES>>

Replace the blown fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK RAIN AND LIGHT SENSOR POWER SUPPLY

(+) (−) Voltage (Approx.)
Rain and light sensor
Connector Terminal
R20 1 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness.

CHECK RAIN AND LIGHT SENSOR GROUND CIRCUIT

Rain and light sensor (−) Continuity
Connector Terminal
R20 3 Ground YES

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness.

CHECK RAIN AND LIGHT SENSOR LIN CIRCUIT

  2. BCM Rain and light sensor Continuity
    Connector Terminal Connector Terminal
    M62 166 R20 2 YES
Rain and light sensor (-) Continuity
Connector Terminal
R20 2 Ground NO

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace harness.

CHECK BCM LIN CIRCUIT

(+) (-) Voltage (Approx.)
BCM
Connector Terminal
M62 166 Ground Refer to Reference Value (With Type A Meter).

Is the inspection result normal?

YES>>

Replace rain and light sensor. Refer to Removal and Installation.

NO>>

Replace BCM. Refer to Removal and Installation.

    Dtc/circuit Diagnosis. Front Washer Circuit
    Component Function Check CHECK FRONT WASHER OPERATION When the front washer switch is turned to the ON position the front washer should operate. Is front washer operation normal...
    Dtc/circuit Diagnosis. Washer Fluid Level Switch Circuit
    Diagnosis Procedure CHECK WASHER FLUID LEVEL SWITCH CIRCUIT Disconnect combination meter and washer fluid level switch connector. Check continuity between combination meter harn...

    Other materials:

    U0146 Can Communication
    DTC Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a N ...

    Removal and Installation. Washer Fluid Level Switch
    Removal and Installation CAUTION: When washer fluid level switch is removed, washer fluid may come out, so be prepared with a container to receive the fluid and never allow fluid to be sprinkled. REMOVALTurn the steering wheel to improve access to the washer tank near the front tire (RH). Re ...

    Brake Warning Lamp
    Component Function Check CHECK BRAKE WARNING LAMP FUNCTION (1) Check that brake warning lamp in combination meter turns ON for approximately 1 second after ignition switch is ON (before engine start). Is the inspection result normal? YES>> GO TO 2. NO>> Refer to Diagnosis Pr ...