Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U3d01-51 Fota

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U3d01-51 Fota

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U3D01-51

FOTA

(FOTA) 		Diagnosis condition Ignition switch is ON.
Signal (terminal) BCM (CPU).
Threshold When a CPU functional abnormality is detected by BCM internal self-diagnosis.
Diagnosis delay time Within 2 seconds.

POSSIBLE CAUSE

BCM

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness.

    Dtc/circuit Diagnosis. U3d00-06 Cell Voltage Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U3D00-06 Cell voltage circuit (Cell voltage circuit) Diagnos...
    Dtc/circuit Diagnosis. Power Supply and Ground Circuit
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuses are not blown (open): With type A meter Unit Location Fuse No. Capacity 28 Battery power suppl...

    Other materials:

    Intermittent Incident
    Intermittent Incident DESCRIPTIONSometimes the symptom is not present when the vehicle is brought in for service. If possible, re-create the conditions present at the time of the incident. Doing so may help avoid a No Trouble Found Diagnosis. The following section illustrates ways to simula ...

    Drivetrain Can Communication 1 Circuit
    Diagnosis Procedure CHECK CAN DIAGNOSIS Check the CAN diagnosis results from CONSULT to see that the drivetrain CAN communication 2 circuit has no malfunction. Is the drivetrain CAN communication circuit 2 normal? YES>> GO TO 2. NO>> Check and repair drivetrain CAN communication ...

    Removal and Installation. Inside Key Antenna
    Japan Production Models Removal and Installation REMOVALRemove luggage rear plate. Refer to Removal and Installation. Remove inside key antenna fixing clips , and then remove inside key antenna . INSTALLATIONNote the following items, and then install in the reverse order of removal.CAUTION: N ...