Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U3d00-06 Cell Voltage Circuit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U3D00-06 |
Cell voltage circuit (Cell voltage circuit) |
Diagnosis condition | Ignition switch is ON. |
| Signal (terminal) | BCM (CPU). | ||
| Threshold | When a CPU functional abnormality is detected by BCM internal self-diagnosis. | ||
| Diagnosis delay time | Within 2 seconds. | ||
POSSIBLE CAUSE
-
BCM
-
Software automatic update function (OTA)
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF-DIAG RESULT
CONSULT
-
Ignition switch ON and wait for 2 seconds or more.
-
Select “Self diagnosis result” mode of “BCM”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace BCM. Refer to Removal and Installation.
NO>>Repair or replace harness.
Other materials:
Lane Departure Warning (LDW)
Basic information
WARNING
Incorrect use of the LDW system may lead to serious injury. This feature only warns the driver of unintended lane departure; it does not steer the Nissan Rogue or prevent loss of control. The driver must always remain attentive.
The LDW system activates when driving a ...
P060c Ecm
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P060C
00
Control module
(Internal Control Module Main Processor Performance)
Diagnosis condition
—
Signal (terminal)
—
Threshold
Built-in m ...
System Description. System
Lithium Ion Battery 12v
System Description
SYSTEM DIAGRAM
Component Function
12V sub battery (lithium ion battery)
Refer to 12V Sub Battery (Lithium Ion Battery).
Combination Meter
Receives li-ion battery error signal from 12V sub battery (lithium ion battery) through IPDM E/R via ...
