Nissan Rogue (T33) 2021-Present Service Manual: P0407 Egr Differential Pressure Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P0407 Egr Differential Pressure Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P0407 00

EGR SENSOR B

(EGR sensor B circuit low) 		Diagnosis condition Ignition switch ON
Signal EGR differential pressure sensor signal
Threshold An excessively low differential pressure from the sensor is sent to ECM
Diagnosis delay time 5 seconds

POSSIBLE CAUSE

  • Harness or connectors (EGR differential pressure sensor circuit is open or shorted.)

  • EGR differential pressure sensor

FAIL-SAFE

Fail safe mode Nissan Ariya Vehicle behavior
Device fix mode

  • This mode fixes the electric IVT control actuator and the EVT control solenoid valve in the reference position.

  • A control signals is not transmitted to the EGR volume control valve and the EGR volume control is deactivated.

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more at ignition switch ON.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON and wait at least 5 seconds.

  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK EGR DIFFERENTIAL PRESSURE SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.

  2. Disconnect EGR differential pressure sensor harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between EGR differential pressure sensof harness connector and ground.

    + −

    Voltage

    (Approx.)
    EGR differential pressure sensor
    Connector Terminal
    F89 3 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

GO TO 5.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity betweenEGR differential pressure sensor harness connector and ECM harness connector.

    + − Continuity
    EGR differential pressure sensor ECM
    Connector Terminal Connector Terminal
    F89 1 F71 106 Existed

  4. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace error-detected parts.

CHECK EGR DIFFERENTIAL PRESSURE INPUT SIGNAL CIRCUIT

  1. Check the continuity between EGR differential pressure sensor harness connector and ECM harness connector.

    + − Continuity
    EGR differential pressure sensor ECM
    Connector Terminal Connector Terminal
    F89 2 F71 93 Existed

  2. Also check harness for short to ground and to power.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected parts.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR

Check the EGR differential pressure sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Check intermittent incident. Refer to Intermittent Incident.

NO>>

Replace EGR differential pressure sensor.

CHECK EGR DIFFERENTIAL PRESSURE SENSOR POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between EGR differential pressure sensor harness connector and ECM harness connector.

    + − Continuity
    EGR differential pressure sensor ECM
    Connector Terminal Connector Terminal
    F89 3 F71 80 Existed

  4. Also check harness for short to ground and short to power.

Is the inspection result normal?

YES>>

Perform the trouble diagnosis for power supply circuit.

NO>>

Repair or replace error-detected parts.

    P0404 Egr Volume Control Valve
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0404 00 EGR A CONTROL (EGR A control circuit range/performance)...
    P040b Egr Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P040B 00 EGR TEMP SENSOR A (EGR temperature sensor A circuit ran...

    Other materials:

    Basic Inspection. Additional Service When Replacing Ecm
    Description Performing the following procedure can automatically activate recommunication of ECM and Intelligent Key unit, but only when the ECM is replaced with a new one*. For details, refer to Work Procedure.*: New one means a virgin ECM that has never been energized on-board.(In this step, ...

    B24a4-11 Intake Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B24A4-11 INTAKE SENSOR (Intake sensor) Diagnosis condition Ignition switch ON Signal (Terminal) Intake sensor signal Threshold The intake sensor rec ...

    Liquide de lave-vitres
    Type A (si le véhicule en est équipé) Type B (si le véhicule en est équipé) Type A : Vérifiez le niveau du liquide dans le réservoir de lave-vitres. Si le niveau est insuffisant, ajoutez du liquide de lave-vitres approprié. Type B : Pour contrôler le niveau, obstruez l’ori ...