Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B2428-44 Automatic Back Door Control Unit
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B2428-44 |
Automatic back door control unit (Automatic back door control unit) |
Diagnosis condition | All times |
| Signal (terminal) | — | ||
| Threshold | Automatic back door control unit internal malfunction (data memory error) | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Automatic back door control unit
FAIL-SAFE
Inhibit automatic back door system all function
DTC CONFIRMATION PROCEDURE
DTC CONFIRMATION
CONSULT
-
Ignition switch ON.
-
Select “Self diagnosis result” mode of “AUTOMATIC BACK DOOR”.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
DTC Diagnosis Procedure
REPLACE AUTOMATIC BACK DOOR CONTROL UNIT
When DTC B2428-44 is detected, replace automatic back door control unit.
>>
Replace automatic back door control unit. Refer to Removal and Installation.
Other materials:
Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
Work Flow
CUSTOMER INTERVIEWInterview
the customer if possible, to determine the conditions that exist when
the noise occurs. Use the Diagnostic Worksheet during the interview to
document the facts and conditions when the noise occurs and any customer
comments. Refer to Diagnostic Worksheet ...
Basic information
The following are approximate capacities for your Nissan Rogue.
Actual refill capacities may vary slightly. When refilling, always follow the procedure described in the "8. Do-it-yourself" section to confirm the proper amount for your Nissan Rogue.
Fuel
Engine oil
Drain and refill
Genuine "NI ...
Basic Inspection. Additional Service When Replacing Automatic Back Door Control Unit
Description
When replacing automatic back door control unit necessary to perform
initial setting to operate automatic back door system normally. Refer to
Work Procedure.
Work Procedure
STEP 1
CONSULT
Select “Reset auto back door status” in “Work supports” mode of "AUTOMATIC BACK ...
