Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2175-87 Can Comm Err (avm)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2175-87 Can Comm Err (avm)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U2175-87

CAN comm err (AVM)

[CAN communication error (around view monitor)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2175-57 Can Comm Err (avm)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U2175-57 CAN comm err (AVM) [Control area network communicat...
    Dtc/circuit Diagnosis. U2176-57 Can Comm Err (ccm/st Angle Sensor)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U2176-57 CAN comm err (CCM/ST angle sensor) [Control area ne...

    Other materials:

    Calibration of Decel G Sensor
    Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. Refer to Work Procedure. ×: Required —: Not required Procedure Decel G sensor calibration Removing/ installing ABS actuator and electric unit (control unit) × ...

    Symptom Diagnosis. Entry/exit Assist Function Does Not Operate
    Diagnosis Procedure CHECK SYSTEM SETTING Check system setting. Refer to Description. Check entry/exit assist function operation. Does it operate normally? YES>> Entry/exit assist function is normal. NO>> GO TO 2. CHECK DOOR SWITCH (FRONT LH) Check door switch (fro ...

    U2148 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2148 83 CAN comm err (brake control unit) [CAN comm err (brake control unit)] Diagnosis condition Ignition switch ON Signal (terminal) CAN communicati ...