Nissan Rogue (T33) 2021-Present Service Manual: U2148 Can Comm Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U2148 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U2148 83

CAN comm err (brake control unit)

[CAN comm err (brake control unit)] 		Diagnosis condition Ignition switch ON
Signal (terminal) CAN communication signal
87 Threshold ECM is not receiving CAN communication signal other than OBD (emission related diagnosis).
Diagnosis delay time 30 seconds or more

POSSIBLE CAUSE

  • Harness or connectors (CAN communication line is open or shorted)

  • ABS actuator and electric unit

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U2148 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Ignition switch OFF and wait at least 10 seconds.

  2. Ignition switch ON.

  3. Ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 11 V at idle.

>>

GO TO 3.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Ignition switch ON and wait at least 3 seconds.

  2. Check 1st trip DTC.

Is DTC U2148 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U2148 is displayed with DTC P0607, first perform the confirmation procedure (trouble diagnosis) for DTC P0607.

Is DTC P0607 detected?

YES>>

Proceed to DTC Description.

NO>>

Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    U2141 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2141 57 CAN comm err (TCM) [CAN comm err (TCM)] Diagnosis condi...
    U214a Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U214A 83 CAN comm err (AWD/4WD) [CAN comm err (AWD/4WD)] Diagnos...

    Other materials:

    P0420 Three Way Catalyst Function
    DTC Description The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2.A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage capacity decreases, ...

    Fuel Pump Control Module
    Component Inspection CHECK FUEL PUMP CONTROL MODULE (FPCM) Check the voltage between FPCM terminals under the following conditions. FPCM Condition Voltage (Approx.) Connector + − Terminal B97 6 5 For 1 second after turning ignition switch ON 9.9 V More than ...

    Dtc/circuit Diagnosis. Rear Window Defogger Switch
    Component Function Check CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION Check that the indicator lamp of rear window defogger illuminates when rear window defogger switch ON. Is the inspection result normal? YES>> Rear window defogger switch function is OK. NO>> Refer to Diagnosis P ...