Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U2148-87 Can Comm Err (brake Control Unit)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U2148-87 Can Comm Err (brake Control Unit)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC Detection Condition
U2148–87

CAN comm err (brake control unit)

[CAN communication error (brake control unit)]
Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2141-87 Can Comm Err (tcm)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...
    Dtc/circuit Diagnosis. U2152-57 Can Comm Err (adas Control Unit)
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U2152-57 CAN comm err (ADAS control unit) [Control area netw...

    Other materials:

    Car phone or CB radio
    When installing a car phone or CB radio in your Nissan Rogue, follow these precautions to avoid interference with electronic modules or wiring systems. WARNING Do not use a handheld cellular phone while driving. It is unsafe and may be prohibited in some regions. If a call must be made while the ...

    Basic Inspection. Intelligent Key Interlock Storing
    Description Always perform the Intelligent Key interlock function storage when the driver seat control unit is replaced. The Intelligent Key interlock function will not operate normally if no memory storage is performed. For details, refer to Work Procedure. Work Procedure Intelligent Key I ...

    Egr Differential Pressure Sensor
    Component Inspection CHECK EGR DIFFERENTIAL PRESSURE SENSOR Turn ignition switch OFF. Remove EGR differential pressure sensor hose (intake and exhaust). Install pressure pump to EGR differential pressure sensor port (intake side). Turn ignition switch ON and check output voltage ...