Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Power Seat Switch Ground Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: Power Seat Switch Ground Circuit

Diagnosis Procedure

CHECK POWER SEAT SWITCH GROUND CIRCUIT (OPEN)

  1. Ignition switch OFF.

  2. Disconnect power seat switch LH connector and driver seat control unit connector.

  3. Check continuity between power seat switch LH harness connector and driver seat control unit harness connector.

    Power seat switch LH Driver seat control unit Continuity
    Connector Terminal Connector Terminal
    B215 4 B213 32 Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. Seat Memory Switch
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Memory switch 1”, “Memory switch 2” and “Set switch” in “Data monitor” mode of “DRI...
    Dtc/circuit Diagnosis. Power Supply and Ground Circuit (driver Seat Control Unit)
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open). Signal name Fuse No. Battery power supply 54 (20A) Is the fuse blown (open...

    Other materials:

    P2480 Exhaust Gas Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2480 00 Exhaust gas temp sensor bank 1 (Exhaust Gas Temperature sensor Circuit/Open Bank 1 Sensor 5) Diagnosis condition Ignition switch ON Signal — ...

    Basic information
    WARNING Radio waves from the Nissan Rogue Intelligent Key may interfere with electric medical equipment. Users with pacemakers should consult the manufacturer about possible effects. The Intelligent Key emits radio waves when buttons are pressed. FAA guidelines warn that these signals may affect ...

    Dtc/circuit Diagnosis. Lifting Switch
    Component Function Check CHECK FUNCTION CONSULT Ignition switch ON. Select “Lifting switch (Up)” and “Lifting switch (Down)” in “Data monitor” mode of “DRIVER SEAT”. Check lifting switch signal under the following conditions. Monitor item Condition Status ...