Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Power Supply and Ground Circuit (driver Seat Control Unit)

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Dtc/circuit Diagnosis :: Power Supply and Ground Circuit (driver Seat Control Unit)

Diagnosis Procedure

CHECK FUSE

  1. Ignition switch OFF.

  2. Check that the following fuse is not blown (open).

    Signal name Fuse No.
    Battery power supply 54 (20A)

Is the fuse blown (open)?

YES>>

Replace the blown (open) fuse after repairing the affected circuit.

NO>>

GO TO 2.

CHECK BATTERY POWER SUPPLY VOLTAGE

  1. Disconnect driver seat control unit connector.

  2. Check voltage between driver seat control unit harness connector and ground.

    (+) (-) Voltage
    Driver seat control unit
    Connector Terminal
    B214 48 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair the driver seat control unit battery power supply circuit.

CHECK GROUND CIRCUIT (OPEN)

Check continuity between driver seat control unit harness connector and ground.

Driver seat control unit (—) Continuity
Connector Terminal
B214 51 Ground Yes

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Repair the harness or connector.

    Dtc/circuit Diagnosis. Power Seat Switch Ground Circuit
    Diagnosis Procedure CHECK POWER SEAT SWITCH GROUND CIRCUIT (OPEN) Ignition switch OFF. Disconnect power seat switch LH connector and driver seat control unit connector. Check co...
    Symptom Diagnosis. Manual Function Does Not Operate
    All Component Diagnosis Procedure CHECK DRIVER SEAT CONTROL UNIT POWER SUPPLY AND GROUND CIRCUIT Check driver seat control unit power supply and ground circuit. Refer to Diagnos...

    Other materials:

    Symptom Diagnosis. Parking Brake Does Not Operate
    Description The parking brake is not applied even when the parking brake switch is pulled. Diagnosis Procedure PERFORM THE SELF DIAGNOSIS RESULT CONSULT Select "Self diagnosis result" mode of "ABS". Is DTC detected? YES>> Check the DTC. Refer to DTC Index. NO>> GO TO 2. CHEC ...

    P2618 Crankshaft Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P2618 00 Crankshaft position signal (Crankshaft position signal output circuit low) Diagnosis condition Engine running at idle Signal (terminal) Cranks ...

    Diagnosis System (front Camera Unit)
    Diagnosis Description APPLICATION ITEMSCONSULT performs the following functions via CAN communication using front camera unit. Diagnosis mode Description Self Diagnostic Result Retrieve DTC from ECU and display diagnostic items Data Monitor Monitor the input/output signal of the cont ...