Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Door Does Not Lock/unlock with Intelligent Key
Description
All doors do not lock/unlock using Intelligent Key button.
NOTE:
Before starting diagnosis check that vehicle condition is as shown in “Conditions of Nissan Ariya vehicle”, and check each symptom.
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | OK | OK | OK | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
Registered Intelligent Key is within the detection area of remote keyless entry receiver.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY OUTPUT SIGNAL
Use SIGNAL TECH II to check Intelligent Key output signal. For the inspection method and how to use SIGNAL TECH II, refer to “NISSAN/INFINITI SIGNAL TECH II USER GUIDE”.
Is the inspection result normal?
YES>>Replace Intelligent Key unit. Refer to Removal and Installation.
NO>>Replace Intelligent Key.
Other materials:
B2721-88 Center Sensor [rl]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2721-88
CENTER SENSOR [RL]
(Center sensor [RL])
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
Communication error
D ...
B Terminal Circuit
Diagnosis Procedure
CHECK “B” TERMINAL CONNECTION
Ignition switch OFF.
Check if “B” terminal is clean and tight.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Repair “B” terminal connection.
CHECK “B” TERMINAL CIRCUIT
Check voltage between g ...
Hd Map (hd Map Module)
B14a0-45 Control Module
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition
B14A0
45
Control module
1
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
Internal error
Diagnosis delay ti ...
