Nissan Rogue (T33) 2021-Present Service Manual: Symptom Diagnosis :: Intelligent Key System All Functions Cannot Operate (all Keys)
Description
Intelligent Key system all functions cannot operate (door lock and engine start).
SYMPTOM TABLE (BOTH INTELLIGENT KEYS HAVE THE SAME SYMPTOMS)
| Door lock operation (remote keyless entry) | Door lock operation (request switch of front/rear/back door) or trunk/back door open operation (opener switch of trunk/back door panel) | Engine started with push-button ignition switch operation (registered Intelligent Key is within the detection area of inside key antenna) | Engine started with push-button ignition switch operation (registered Intelligent Key placed next to push-button ignition switch) | Unlock operation when approaching the Nissan Ariya vehicle, lock operation when away from the vehicle (registered Intelligent Key is within the detection area of outside key antenna) |
|---|---|---|---|---|
| NG | NG | No start | No start | OK |
CONDITIONS OF VEHICLE (OPERATING CONDITIONS)
“ENGINE START BY I-KEY” setting in “WORK SUPPORT” mode of “HANDS FREE MODULE” is ON.
DIAGNOSIS PROCEDURE
Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK INTELLIGENT KEY SYSTEM SYMPTOM TABLE
Check Intelligent Key system symptom table.
Refer to Diagnosis Procedure.
>>
GO TO 2.
CHECK INTELLIGENT KEY-1
For both Intelligent Key that cannot be used for door lock and unlock, check that the Intelligent Key belongs to the Nissan Ariya vehicle to be checked.
-
Check if the Intelligent Key that is checked is the Intelligent Key for a different NISSAN Nissan Ariya vehicle that the user owns.
-
Check that the Intelligent Key buttons match the vehicle specifications.
Does the Intelligent Key belong to the Nissan Ariya vehicle to be checked?
YES>>GO TO 3.
NO>>Check Intelligent Key button operation using a registered Intelligent Key that belongs to the Nissan Ariya vehicle.
CHECK INTELLIGENT KEY-2
Check the inside of the both Intelligent Key for rust or corrosion by water. Simultaneously check the internal circuits for damage.
Is the inspection result normal?
YES>>GO TO 4.
NO>>Replace Intelligent Key.
REGISTER INTELLIGENT KEY
-
Register the Intelligent Key again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>GO TO 5.
REPLACE INTELLIGENT KEY
-
Replace the Intelligent Key and perform registration again.
-
Check operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>GO TO 6.
REPLACE INTELLIGENT KEY UNIT
-
Replace Intelligent Key unit. Refer to Removal and Installation.
-
Check the operation after replacement.
Is the inspection result normal?
YES>>Inspection End.
NO>>Check intermittent incident. Refer to Intermittent Incident.
Other materials:
Rear View Monitor. Removal and Installation. Rear View Camera
Rear View Camera
Removal and Installation
REMOVALRemove the back door inner finisher. Refer to Removal and Installation.
Remove the rear view camera mounting bolts , And then push the pawls in the direction of the arrow in the figure to remove the rear view camera.
INSTALLATIONInstallation is ...
C10b0-09 Parking Brake Actuator (rh)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C10B0
09
Parking brake actuator (RH)
[Parking brake actuator (right)]
Diagnosis condition
When parking brake is apply
Signal (terminal)
—
Threshol ...
Stop Lamp Circuit
Component Function Check
CHECK STOP LAMP OPERATION
Ignition switch ON.
With operating the brake pedal, check that the stop lamp and high-mounted stop lamp is turned ON.
Depressed
: Stop lamp and high-mounted stop lamp ON
Fully released
: Stop lamp and high-mounted stop lamp O ...
