Nissan Rogue (T33) 2021-Present Service Manual: C1b80-54 Control Module

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / C1b80-54 Control Module

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
C1B80 54 Calibration not completed Diagnosis condition When ignition switch is ON.
Signal (terminal) -
Threshold When calibration is not complete.
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

  • Incomplete programing of chassis control module

  • Chassis control module

FAIL-SAFE

The following functions are suspended.

  • Intelligent trace control function

  • Active ride control function

  • Automatic brake hold function

  • Drive mode selector function

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

With CONSULT

  1. Ignition switch OFF to ON.

    CAUTION:

    Be sure to wait of 10 seconds after ignition switch OFF or ON.

  2. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1B80-54” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM SELF-DIAGNOSIS

With CONSULT

  1. Erase self-diagnosis result for “CHASSIS CONTROL”.

  2. Ignition switch OFF and wait for 10 seconds or more.

  3. Ignition switch ON.

  4. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1B80-54” detected?

YES>>

Perform configuration. Refer to Description.

NO>>

INSPECTION END

    Chassis Control. Dtc/circuit Diagnosis
    C1b8b-82 Hardware Network Seperator System
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B8B 82 Power network separate relay Diagnosis condition When ignition switch is ON. Si...

    Other materials:

    Dtc/circuit Diagnosis. U2152-87 Can Comm Err (adas Control Unit 2)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped ...

    U1cfa Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1CFA 00 Lost communication with USM in secondary ECU (Lost communication with USM in secondary ECU) Diagnosis condition Ignition switch ON Signal (termin ...

    Adjustment of Brake Caliper Initial Position
    Description CAUTION: When performing the following operations, always use CONSULT (It cannot be performed by any means other than CONSULT.), for performing "INITIALIZATION POSITION ADJUSTMENT" of "WORK SUPPORT". Refer to Work Procedure. ×: Required —: not required Procedure INITIALIZATI ...