Nissan Rogue (T33) 2021-Present Service Manual: C1b8b-82 Hardware Network Seperator System

Nissan Rogue (T33) 2021-Present Service Manual / Cruise Control & Driver Assistance :: Driver Assistance System / Chassis Control :: Dtc/circuit Diagnosis / C1b8b-82 Hardware Network Seperator System

DTC Description

DTC DETECTION LOGIC

DTC No. CONSULT screen terms DTC detection condition
C1B8B 82 Power network separate relay Diagnosis condition When ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold Power network separate relay is malfunctioning.
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

Power network separate relay

FAIL-SAFE

Normal control

DTC CONFIRMATION PROCEDURE

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

CHECK DTC DETECTION

With CONSULT

  1. Ignition switch OFF to ON.

    CAUTION:

    Be sure to wait of 10 seconds after ignition switch OFF or ON.

  2. Perform self-diagnosis for “CHASSIS CONTROL”.

Is DTC “C1B8B-82” detected?

YES-1>>

"CRNT" is displayed: Refer to Diagnosis Procedure.

YES-2>>

"PAST" is displayed: INSPECTION END (Erase the memory of self-diagnosis results.)

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK POWER NETWORK SEPARATE SYSTEM

With CONSULT

Perform self-diagnosis for "PNS relay".

Is DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

ERASE SELF-DIAGNOSIS RESULT

With CONSULT

  1. Erase self-diagnosis result for “CHASSIS CONTROL”.

  2. Ignition switch OFF and wait for 10 seconds or more.

>>

INSPECTION END

    C1b80-54 Control Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition C1B80 54 Calibration not completed Diagnosis condition When ignition switch is ON. Signa...
    U0076-00 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U0076 00 Control module communication Bus D Off Diagnosis condition When ignition switch...

    Other materials:

    P044a Egr Volume Contro Valve Position Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P044A 00 EGR SENSOR C (EGR sensor C circuit low) Diagnosis condition Ignition switch ON Signal (terminal) EGR volume control valve signal Threshol ...

    Power Supply and Ground Circuit
    Ecm Diagnosis Procedure CHECK THE BATTERY CABLE Turn ignition switch OFF. Check the battery cable for tightening enough. NOTE: Check the continuity between the battery cable and the battery terminal. Is the inspection result normal? YES>> GO TO 2 ...

    Removal and Installation. Moonroof Switch Assembly
    Removal and Installation REMOVALRemove map lamp finisher. Removal and Installation Disengage moonroof switch assembly fixing pawls using a remover tool, and then remove moonroof switch assembly from map lamp finisher . : Pawl INSTALLATIONInstall in the reverse order of removal. ...