Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: Door Mirror Defogger Lh
Component Function Check
CHECK DOOR MIRROR DEFOGGER LH FUNCTION
CONSULT
-
Ignition switch ON.
-
Select “Rear defogger� in “Active test� mode of "BCM".
-
Touch “On�.
-
Check that the driver side door mirror glass is getting warmer.
NOTE:
When glass is hot, never start inspection until it is cool enough.
Is the inspection result normal?
YES>>Door mirror defogger LH function is OK.
NO>>Refer to Diagnosis Procedure.
Diagnosis Procedure
CHECK DOOR MIRROR LH POWER SUPPLY CIRCUIT
-
Ignition switch OFF.
-
Disconnect door mirror LH connector.
-
Start engine.
-
Check voltage between door mirror LH harness connector and ground.
With automatic drive positioner system (+) (-) Condition Voltage
(Approx.)Door mirror LH Connector Terminal D16 1 Ground Rear window defogger switch ON Battery voltage OFF 0 V Without automatic drive positioner system (+) (-) Condition Voltage
(Approx.)Door mirror LH Connector Terminal D14 6 Ground Rear window defogger switch ON Battery voltage OFF 0 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace harness.
CHECK DOOR MIRROR LH GROUND CIRCUIT
-
Ignition switch OFF.
-
Check continuity between door mirror LH harness connector and ground.
With automatic drive positioner system Door mirror LH — Continuity Connector Terminal D16 9 Ground Yes Without automatic drive positioner system Door mirror LH — Continuity Connector Terminal D14 12 Ground Yes
Is the inspection result normal?
YES>>Replace glass mirror LH. Refer to Removal and Installation.
NO>>Repair or replace harness.
Other materials:
Dtc/circuit Diagnosis. U2a06-88 Comm Bus Off V-Fd
DTC Description
DESCRIPTIONCAN (Controller Area Network) is a serial
communication line for real time applications. It is an on-Nissan Ariya
vehicle multiplex communication line with high data communication speed
and excellent error detection ability. Modern Nissan Ariya vehicle is
equipped ...
Awd. Service Data and Specifications (sds). Service Data and Specifications (sds)
Service Data and Specifications (sds)
Wheel Bearing
Axial end play
0.05 mm (0.002 in) or less
Drive Shaft
Item Standard
Grease quantity
Wheel side
49 – 69 g (1.73 – 2.43 oz)
Final drive side
78 – 98 g (2.76 – 3.45 oz)
Boots installed length*
Wheel ...
Symptom Diagnosis. Ign Off Interlock Door Unlock Function Does Not Operate
Diagnosis Procedure
CHECK “AUTO DOOR UNLOCK� SETTING IN COMBINATION METER
Check “Auto Door Unlock� setting is “IGN OFF�.
Is the inspection result normal?
YES>>
GO TO 2.
NO>>
Set “IGN OFF� in combination meter.
REPLACE BCM
Replace BCM. Refer to Removal and I ...
