Nissan Rogue (T33) 2021-Present Service Manual: On Board Diagnostic (obd) System

Nissan Rogue (T33) 2021-Present Service Manual / Transmission & Driveline :: Transaxle & Transmission / Cvt: Ge0f14a :: System Description / On Board Diagnostic (obd) System

Description

This is an on board diagnosis system which records diagnosis information related to the exhaust gases. It detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the malfunction indicator lamp (MIL) and are stored as DTC in the ECU memory. The diagnosis information can be checked using a diagnosis tool (GST: Generic Scan Tool).

Function of OBD

The GST is connected to the diagnosis connector on the vehicle and communicates with the on-board control units to perform diagnosis. The diagnosis connector is the same as for CONSULT. Refer to Description.

    System
    Cvt Control System System Description SYSTEM DIAGRAM Component Function ECM Mainly transmits the following signal to TCM via CAN communication. Engine and CVT integrated control...
    Diagnosis System (tcm)
    Diagnosis Description 1 Trip Detection Diagnosis and 2 Trip Detection Diagnosis NOTE: “Start the engine and turn OFF the ignition switch after warm-up.” This is defined as 1...

    Other materials:

    Dtc/circuit Diagnosis. U1c01-08 Lin Communication
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition U1C01-08 LIN communication (Local interconnect network communication) Diagnosis condition Ignition switch is ON or OFF (auto ACC status). Signal (terminal) ...

    Symptom Diagnosis. Id Registration Cannot Be Completed
    Description The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit. Diagnosis Procedure NOTE: The Signal Tech II Tool [– (NI-50190)] can be used ...

    Basic Inspection. Configuration
    Description Vehicle specification needs to be written with CONSULT because it is not written after replacing the power steering control module.The configuration requires network connection. CONSULT connects to network and then it downloads the configuration data from the server. Then CONSUL ...